Table of Contents
Advertisement
Parameters
Parameter
Master
Reference Line
Number of Regions
Base Height
External ID
Master Comparison
When you check the Master option, the tool displays several additional settings and disables
measurement anchoring from other tools.
The File and Operation parameters are in an expandable Master section.
Master Parameters
Parameter
File
Operation
Gocator Line Confocal Sensors: User Manual
Description
Toggles a set of settings related to master comparison. For more information, see
Master Comparison below.
Toggles a set of settings related to the reference line. For more information, see
Reference Line on the next page.
Sets the number of height region measurements the tool returns. For each height
region, the tool displays a Height {n} section containing the region's position and
size. The tool also displays a Height{n} Feature drop-down that lets you select the
type of feature for that height region.
Use base height to "set" the Z axis: when enabled, height values are offset from the
base. This is useful if you need to measure between two features, rather than
between a feature and the reference line.
When enabled, the tool displays settings related to the base height: size and
position of the base height's region (Base Height section) and the base height's
feature.
The external ID of the tool that appears in GoHMI Designer. For more information,
see GoHMI and GoHMI Designer on page 688.
Description
The file containing the master (template) profile, created by choosing Save from
the Operation drop-down.
Contains operations related to the master file. One of the following:
Normal: Selected by the tool after you perform another file operation.
l
Create: Saves the current profile as the master. Use this when the master does
l
not exist.
Load: Loads the master file selected in File.
l
Configuring Systems • 200
Advertisement
Table of Contents
