Table of Contents
Advertisement
Programming using TELPRO
wire-free programmer.
Remote Programming Range:
Infra-Red Receiver
Proximity Reader
How to use the TELPRO:
Important:
Each press of a button
is confirmed (as
received) by the
reader/receiver by a
single beep. Press the
TELPRO
™
buttons
gently.
Enter the Master Code and wait for the reader/receiver to start beeping every 4 seconds
Flick Programming Switch SW1 and wait for the reader/receiver to start beeping every 4 seconds
(Remember to turn off the programming switch SW1 when you have finished programming).
Note: An incorrect programming operation is signalled by a series of 3 beeps.
Programming using TELPRO
hard-wired programmer
How to use the TELPRO as a hard wired unit:
Insert the jack connection into the top of the TELPRO unit.
Plug the connector terminal onto J5 on ECP Door Controller.
Enter the Master Code and wait for the unit
to start beeping every 4 seconds
Flick Programming Switch SW1 and wait for the unit
to start beeping every 4 seconds
(Remember to turn off the programming switch SW1
when you have finished programming)
Follow programming instructions.
Flick TELPRO switch to ON - Red LED on the right must light up.
(Remember to turn unit off when finished)
Point TELPRO at the reader/receiver.
Follow programming instructions
OR
Get other manuals https://www.bkmanuals.com
™
as a remote
20 cms - 5 metres
5 cms - 10 cms
OR
™
as a
Important:
Each press of a button is confirmed (as
received) by the Door Controller by a
single beep.
Press the TELPRO
8
Dimensions (mm):
120L x 60W x 25D
ECP290/ECP200
J5
= Access Point 1
J6
= Access Point 2
™
buttons gently.
Advertisement
Table of Contents
