Hitachi Relion 670 Series Operation Manual page 70

Section 7
Operating procedures
• Select the IED menu and click on the Read through fault reports option.
•
Click on the Read through fault reports
The through fault reports are read from the IED, and a confirmation dialog box appears.
IEC18000085 V1 EN-US
Figure 44:
Deleting through fault reports from the IED
In order to delete through fault reports from the IED via PCM600 at function block instance level, proceed
as follows:
1. Select the function block instance from the Through fault monitoring function selection combo box
as shown in
IEC18000086 V1 EN-US
Figure 45:
2. Select the IED menu and click on Clear through fault reports option as shown in
IEC18000087 V1 EN-US
Figure 46:
A confirmation dialog box appears.
64
Read through fault confirmation window
In order to open the TFM tool successfully in PCM600, the configuration between the
PCM600 tool and the IED should match. If the configuration is not same between the
PCM600 tool and the IED, then read configuration from IED via Read from IED option in
PCM600 need to be performed.
A warning message dialog box appears, if the through fault monitoring function is not
configured in the IED.
Figure 45.
Select function block instance
Clear through fault reports
© 2017 - 2023 Hitachi Energy. All rights reserved
button on the tool bar.
IEC18000085-1-en.vsdx
IEC18000087-1-en.vsdx
1MRK500127-UUS Rev. M
GUID-FAAA98A3-E5E7-4A01-BA1E-BF8C35C86CCA v1
IEC18000086-1-en.vsdx
Figure 46.
670 series
Operation manual