Cellularline SEEK - Wireless Stereo Bluetooth Headset With Charging Case Manual

Description

1. Multifunction Button
2. LED
3. Charging Case charge state display
4. USB-C charging port
5. USB to USB-C charging cable

PRELIMINARY OPERATIONS

Charge the Charging Case and earbuds before setting up for the first time.

PHONE CONNECTION: before connecting SEEK to the phone, it is necessary to establish a connection between the two earbuds. Remove the earbuds from the Charging Case. Both LEDs will light up blue, the earbuds will connect with each other within a few seconds and the LED on one or both earbuds will flash alternately red/blue.

Enable Bluetooth on your phone to search for devices, and select SEEK when it is detected.

USE

Switch on: remove the earbuds from the Charging Case or hold down the multifunction button for about five seconds if the earbuds are not in the Charging Case.

Switch off: put the earbuds back in the Charging Case or hold down the multifunction button for about five seconds.

Answer a call: you can answer calls from either earbud by pressing the multifunction button once. If both earbuds are in the Charging Case when a call arrives, remove either the right or left earbud, wait for it to connect and then press the multifunction button to answer.

End a call: you can end calls from either earbud by pressing the multifunction button once.

Voice assistant: press the touch control (1) on the right or left earbud 3 times.

Play/Pause: press the multifunction button on either of the two earbuds once.

FF: press the multifunction button on the right earbud for two seconds to fast forward to the next track.

Rew: press the multifunction button on the left earbud for two seconds to rewind to the previous track.

Speaker volume adjustment: press MFB touch control (1) of the right earbud twice to increase the volume. To decrease it, press MFB touch control (1) of the left earbud twice.

Flat earbud battery indicator: an acoustic signal indicates that the earbud battery is low.

Charging Case charge state indicator: the display shows the charge state of the Charging Case.

Charging the Charging Case: Use the supplied cable to charge the Charging Case. The display will show the percentage charge. Once you have finished charging, disconnect the Charging Case from the power supply.

Charging the Earbuds: the Charging Case has an internal battery for charging the earbuds without a direct power supply, so keep the Charging Case battery charged.

Insert the earbuds in their respective docks and close the Charging Case flap. Charging will start automatically and the LEDs will light up continuously red.

The LEDs will turn off when charging has finished.

Reset: if the device malfunctions, it can be reset to restore initial operation:

• delete the earbud pairing from the phone, disable Bluetooth® and reboot the phone.
• remove the earbuds from the Charging Case and press both multifunction buttons to switch them off
• Once they are off, hold the multifunction button down and pay attention to the LED flashing sequence (on both earbuds):
  • red flash
  • blue double flash
  • red and blue flash
  • red and blue flash (one earbud only)
  • red flash- off

Release the button.

• insert the devices in the Charging Case and close the flap.
• now repeat the initial pairing procedure.

SPECIFICATIONS

Bluetooth®: v5.0
Supported profiles: Headset – Handsfree – A2DP - AVRCP
Range: 10m
Bluetooth® Frequency Range: 2402-2480MHz
Battery voltage: 3.7V
Battery capacity: 30mAh X 2
Charging Case battery capacity: 250mAh
MicroUSB port Voltage (V): 5V
MicroUSB port current (A): 300mAh
ERP power: 8dB
Stand by Time: 10 hours
Talk Time: 3 hours
Play Time: 3 hours
Earbud charging: approximately 1.5 hours
Charging the Charging Case: approximately 2h
Weight: 32g