NIC2-2 · Network ID Camera
its weaker locking mechanism the pin will not be pushed upwards and thus will be able to
unlock the deeper locking mechanism.
3.2.9 Cassette cover plate sub-assembly.
The cassette cover-plate has three sensors mounted which are used to indicate that the cas-
sette is in position for marking. The left and right sensor are touching the front edge of the
cassette while the middle sensor should enter a hole in the cassette. There is a special test
mode in the firmware that will display the status of the sensors. The test mode and the ad-
justment of the sensors are described in a section in the diagnostic chapter.
Triacon AB Sweden
15
Publication no. 201102
September 2003