Table of Contents
Advertisement
EN
OPERATING INSTRUCTIONS
REMOTE CONTROL PAIRING:
*Before using the remote control, please remove the
insulating spacer and reinstall the battery.
Turn on the light, press and hold the "
on the remote for about 10 seconds until the
indicator alternately flashes blue to enter pairing
mode. Then, close the remote to the light until the
indicators on the remote and light unit are constantly
blue for 2 seconds, confirming a successful pairing.
REMOTE CONTROL OPERATION:
ON/OFF: Press and hold the "
second
ADJUST BRIGHTNESS: Click the "
CHANGE MODE: Double click the "
FLASH MODE: Double click the "
FULL OUTPUT MODE (1600LM/2600LM): Click the
□
"
" button to go into Full Output Mode and click the
○
□
"
"/"
" button to return to the previous mode.
*The remote control will enter sleep mode if the light
is turned off for 48 hours without any operation.
Click the light's button to activate it or long-press the
light's button to turn it on, and the remote control
can work normally.
○
""
○
□
"/"
" button for 1
○
" button
○
" button
□
" button
□
" buttons
Advertisement
Table of Contents
Need help?
Do you have a question about the RAY 2600B and is the answer not in the manual?
Questions and answers
My charging cable isn't long enough to recharge my battery. I have a Magicshine RAY 2600B bicycle headlamp. Is there a way to charge the battery without taking the lamp from the handlebars? When I received my headlamp it did not come with any paperwork, charging cable or remote. I didn't think too much about this because I have several charging cables and I thought that I would never use the remote, and I knew I could get the manual on line. The manual doesn't say a word about charging the battery. Thanks for your attention.
Yes, the Magicshine RAY 2600B bicycle headlamp can be charged without removing it from the handlebars, as it charges via a USB-C cable.
This answer is automatically generated