Carpet Cleaning; Cleaning/Maintenance; General Cleaning Work - Parkside PWS 20 C2 Original Instructions Manual

Never reach into the water to
be suctioned up. Danger of
electric shock.
When the container (7) is full, the
suction opening is shut off by a
float, and suction is then cut off.
Switch the device off, remove the
water tank (
tor head (4) and empty the con-
tainer (7). Afterwards, make sure to
re-assemble the device completely.
If the container is full, a float closes
the suction opening and the suction
process is interrupted.
1. Turn off the device.
2. Empty the container (7) by
- removing the water tank (
and the motor head (4) and tipping
out the container (7),
or
- opening the drain plug (26) and let-
ting the container (7) run empty.
draining in this way, make
sure that no liquids remain in
the device. Tip the contain-
er (7) slightly when only a small
amount of liquid runs out.
Afterwards, make sure to re-assemble the
device completely.
If foam or liquid exits, switch off the
machine immediately.
The device must not be used by
as a water pump. It is designed
to suck up an air/water mixture.
When wet vacuuming, make sure
that the suction cup is always hig-
her than the water surface to be
vacuumed! Otherwise, negative
pressure/suction (siphon effect)
could occur.
19) and the mo-
19)

Carpet cleaning

For carpet cleaning, only use the
washer nozzle with the attachment
for hard surfaces (
washer nozzle for cleaning uphol-
stery ( 23).
1. Place the foam filter (11) onto the filter
basket (4a). To prevent the foam fil-
ter (11) from tearing,
­ Only insert dry filters;
- Before inserting, twist the edge of
the filter slightly and then roll it back.
2. Fill the water tank (
water (max. 4 l). Pay attention to the
markings on the container (
3. Pull (do not push!) the nozzle
( 23/24) in rows over the carpet/
upholstery.
Overlap the rows a bit to ensure thor-
ough cleaning.
4. Press the lever for the spray function
( 15a) on the handle part to turn on
the spray function.
5. Empty the container (7) immediately
after vacuuming, as it is not designed
to store liquids (see "Cleaning/Mainte-
nance").
In case of excessive dirt or stains,
add some cleaning agent, e.g. car-
pet and upholstery cleaner (
to the water tank.

Cleaning/Maintenance

Pull out the mains plug.
Danger of electric shock.

General Cleaning Work

Never hose the appliance
down with water. Never use
GB
24) or the
19) with fresh
19).
25),
23