PLDT Home PWN3701 - Wireless-N Repeater Quick Installation Guide

Package Contents

• 1 x WiFi Repeater
• 1 x Quick Installation Guide

Overview

1. WPS : Press 1 second to trigger WPS function
2. LED Indicators:
   • Power:
     • On - Power On
     • Off - Power Off
   • WLAN:
     • On - Wireless turn On
     • Off - Wireless turn Off
   • WPS:
     • On - WPS feature turn On
     • Off - WPS feature turn Off
   • Signal Strength:
     • LED On: Low Signal
     • LEDs On: Medium Signal
     • LEDs On: Good Signal
     • LEDs On: Excellent Signal
3. Reset:
   Press 1 - 5 seconds to reboot Repeater.
   Press > 5 seconds to reset to factory default and reboot.
4. AC Power Input

Note:
The illustration in this document may appear different from your model.

Hardware Installation

Router WiFi Range

WiFi Repeater Range

Connecting to the Root AP

Method 1: With WPS button

Step 1. Plug the Wifi Repeater into the electrical socket and power on the electrical socket. The Power LED on Wifi Repeater will illuminate. Wait until the WLAN and WPS LEDs light up.

Step 2. Press the Wi-Fi Protected Setup (WPS) button on your wireless router or root AP.

Step 3. Press the WPS button of Wifi Repeater for 1 second until the WPS LED starts to blink.

Note 1. The Signal Strength LEDs will illuminate to show the link quality once connected to the root AP.
Note 2. Both buttons must be pressed within 2 minutes.

Method 2: With Web Configuration

Step 1. Connect your computer to Wifi Repeater via wireless.
The wireless network (SSID) shall appear as "PLDTHOMEREPEATER".

Note: The Wi-Fi Key or password can be found on the label pasted on Wifi Repeater.

Step 2. Open web browser and type http://192.168.1.253 in the browser's address box. This is the default IP address for Wifi Repeater.
The default user name is "admin" and password is "1234".

Step 3. Click on Quick Setup Wizard -> Start

Click <Next>, the repeater will scan and find the available wireless network.

Select the wireless network or root AP that you want to connect to, and click on <Next>.
Key in the wireless password of the wireless router or root AP, and click on <Next> to proceed.

Please obtain the wireless password from the owner of the wireless router or root AP. The repeater will not able to connect to the wireless router or root AP if the password is incorrect.

Check and confirm if the information are correct.
Click <Finish> and the Wifi Repeater will attempt to connect to the root AP.

Note: The Signal Strength LEDs will illuminate to show the link quality once connected to the root AP.