Page 2
SAFETY AND WARNINGS READ AND SAVE THIS GUIDE WARNING! Electric Shock Hazard WARNING! To avoid hazard, follow these instructions carefully before installing or using this appliance. Failure to follow this advice may result in electric shock or death. Please make this information available to the person installing the appliance—doing so could reduce your installation costs.
INSTALLATION CONSIDERATIONS BEFORE INSTALLATION AFTER INSTALLATION Ensure that: Ensure that: the oven cavity is square and level based on the required dimensions the oven door can open fully without obstruction the installation will comply with all clearance requirements and applicable standards and the oven is not sealed into the cabinetry with silicone or glue.
COMPONENTS STANDARD ACCESSORY KIT INSTALLATION KIT Part No. 580720 Supplied with all models. Supplied with all models. Roast dish Grid Grill rack Food probe Screws (2) Cabinetry trim (1) Full extension sliding shelf Step down wire shelf STEAM ACCESSORY KIT Part No.
PRODUCT DIMENSIONS FRONT PROFILE OS60SDT PRODUCT DIMENSIONS A Overall height of oven B Overall width of oven C Overall depth of oven (excluding handle and dials) D Height of chassis E Width of chassis F Depth of chassis G Depth of oven frame and control panel (between front of chassis and front of oven door) H Depth of oven door when fully open (measured from front of control panel) PLAN...
CABINETRY DIMENSIONS PROUD INSTALL 16-20mm PROFILE PLAN FLUSH INSTALL OS60SDT 16-20mm CABINETRY DIMENSIONS A Minimum inside width of cavity B Overall width of cabinetry C Minimum inside height of cavity D Overall height of cabinetry E Minimum inside depth of cavity If installing a cooktop above the oven, ensure adequate clearance is provided as per the cooktop manufacturer’s instructions.
Page 7
DISCARD PACKAGING RESPONSIBLY Remove the packaging from the side and accessories box from the top of the oven, and set aside. Recycle responsibly...
Page 8
CONNECT THE OVEN TO THE MAINS SUPPLY This oven must be connected to the mains power supply only by a suitably qualified person. Ensure cable This oven must be earthed. clamp is tightened Before connecting the oven to the mains power supply, check that: the domestic wiring system is suitable for the power drawn by the oven (as specified on the rating plate).
SECURE THE OVEN TO THE CABINETRY cavity Do not lift the oven by the door handle. Do not over-tighten the screws. Do not seal the oven into the cabinetry with silicone or glue. This makes future For dark cabinetry, the supplied trim can be used to servicing difficult.
INSTALLER CHECKLIST TO BE COMPLETED BY THE INSTALLER TEST OPERATION: Ensure the oven is level and securely fitted to the cabinetry. Turn on the oven. The display should light up. Open the oven door slowly until it is fully open and check there is adequate Set the clock following the instructions in the ‘User guide’.
Need help?
Do you have a question about the OS60SMTDB1 and is the answer not in the manual?
Questions and answers