Power-On Debug Specifications - Fujitsu F2MC-16L Hardware Manual

1.9

Power-On Debug Specifications

The emulator has a power-on debug function that executes a program immediately
after power is turned on to the evaluation MCU.
I Power-on debug specifications
The power-on debug function
after the power-on sequence by using the PLEV pin
This function must be preset before it can be used.
For details about presetting the function, see the Softune Workbench Operation Manual.
*1: The power-on debug function is enabled if supported by the evaluation MCU.
Before using the function, consult the Fujitsu Sales Dept. or Support Dept.
Sales Department or the Support Department of Fujitsu Limited.
*2: The PLEV pin name may depend on the evaluation MCU used.
Before using the function, consult the Fujitsu Sales Dept. or Support Dept.
I Operational flow
Figure 1.9-1 "Flow of the power-on debug operation" shows the flow of the power-on debug
operation.
(*1)
verifies the processing of an executed program immediately
Figure 1.9-1 Flow of the power-on debug operation
·
Enabling of power-on debug
·
Setting of the power-off detection level
Execution of a program
User system powered off
(detection of power-off)
User system powered on?
Yes
No
Operation stabilizing
time elapsed?
Yes
Execution of a program.
Get other manuals https://www.bkmanuals.com
1.9 Power-On Debug Specifications
(*2)
of the evaluation MCU.
UVCC LED is off
No
UVCC LED goes on
11