Nova 8901W Quick Assembly

HOW TO
ASSEMBLE YOUR
Drop Arm Commode
Item # 8901W
Capacity not to exceed 300 lb
Bucket & Lid
1
Remove all parts from box:
1 drop arm commode with seat and lid, 1 bucket with lid, 1 splash guard, 1 backrest, and 4
leg extensions.
2
To adjust the legs and seat height, place the seat face down and depress the silver push
button on one of the legs of the commode and slide a leg extension over it. Lengthen or
shorten the leg extension to the desired position. Once the desired
position is found, ensure that the silver push button protrudes from
the adjustment hole of the leg extension and is fully engaged so that
it does not move. Adjust the other three legs to the same length, and
make sure that the commode sits level.
3
Lay the front end of the commode face down and Insert the backrest
into the tube slots under the seat. Depress the silver push buttons on
each side of the backrest until they protrude from the adjustment hole
and are fully engaged into the user's desired setting. Ensure the silver
push buttons are fully engaged by pulling on the back.
4
Lift the seat and place the bucket in the center of the commode in between the
bucket hangers. When using the commode over a toilet, replace the bucket with
the splash guard.
HOW TO USE YOUR
Drop Arm Commode
1
Lowering the drop arms: On the side of the arms, push in the RED spring loaded
release button and push down on the drop arm.
Raising the drop arms: Pull up on the arms until the RED spring loaded release
button completely pops out and is locked.
2
The commode should be low enough to ensure that your feet touch the floor when sitting on
it, but high enough to enable easier sitting and standing.
3
After use, remove the bucket, discard waste and sanitize.
Splash Guard
QUICK ASSEMBLY
SIMPLE STEPS
Back Rest
Follow these
Leg Extensions