Settings - Bosch CS5800iAW 180 MCP Operating Instructions Manual

4.5

Settings

Menu > Press menu button in the Start menu at the top on the left to call
up the "General settings" menu.
Menu item Description
Language Set the language of the menu texts shown in the
display.
Time of Day Set the current time. This setting is used as the basis
for the holiday program, thermal disinfection and
weekday, for example.
Date format Set the required date format and time. This setting is
used as the basis for the holiday program, thermal
disinfection and weekday, for example.
Date Set the current date. This setting is used as the basis
for the holiday program, thermal disinfection and
weekday, for example.
Auto. time Activate or deactivate the automatic changeover
switchover between summer and winter time. If [Yes] is set, the
time setting automatically changes (from 02:00 to
03:00 on the last Sunday in March and from 03:00
to 02:00 on the last Sunday in October).
Time correction Option for correcting the time if the time deviates in
factor the control panel.
Suppress As soon as an alarm occurs, a warning signal sounds.
warning sound The signal output can be deactivated for any length
of time.
• [Operation mode]
– [On]:
The buzzer is always active.
– [Off]:
The buzzer is never active.
– [Auto]:
The buzzer is normally active, but switched of
during the set interval.
• [Start Time]:
Set the start time for switching off the summer.
• [End time]:
Set the end time for switching off the summer.
Brightness Change the display brightness (to make it easier to
read).
Display off after Set the time delay (following the last activity) until
the display is shut down.
Installer contact In this menu the installer contact data are displayed
data (if entered).
Internet In this menu the data for the internet connection are
displayed. The QR code can be scanned with the
phone app to make the connection with the internet
gateway.
• Internet connection
• WLAN network
• IP address
• Server connection
• Internet module software version
• MAC address
• Login data
• Establish connection
– Pairing status
– Activ. Hotsp.
– Activate WPS
• Terminate connection
• Reset Internet password
Pre plumbed cylinder – 6 721 852 929 (2023/04)
Menu item Description
Standby mode The heat pump is normally switched on. The system
is only switched off in order to carry out
maintenance or similar tasks.
▶ To temporarily switch off the display and the
system:
– Select [Yes]
▶ To switch on the display and the system:
– Press on the display.
– Select [Yes].
Activate keylock Select [On] to activate the child-lock.
Table 8 General Settings
Standby means that the system is completely switched off and no safety
functions, such as frost protection, are active.
Main menu
11