Advertisement
14
CARE AND CLEANING
Spray Arm
varies by model
Glass Trap
Removal
Glass Trap
Replacement
To empty the glass trap:
1.
Pull the glass trap handle up and out
toward you to remove.
2. Empty any debris collected in the
glass trap.
3. Once empty, slide the glass trap
back into the same location as when
removed, then push down to lock
back into position. See image above.
NOTE
Hard water may cause lime deposit
buildup on the interior of the
dishwasher. For cleaning instructions
see "Removing Spots and film" section.
WARNING
Burn Hazard
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in burns.
Outer Door - Clean outer door with warm
soapy water and a dishcloth or sponge.
Rinse with clean water and a dry cloth.
Do not use harsh cleaners. Inside - The
inside of the dishwasher and filter are
self-cleaning with normal use. If needed,
clean around the tub gasket area with a
damp cloth. The filter is self-cleaning.
A glass trap located in the center of the
filter is designed to collect pieces of
broken glass, straws, bones and pits.
Overfill Protector- keeps dishwasher from
overfilling and is located in the left front
corner of the tub.
•
Clean occasionally with household
cleaner containing vinegar or bleach
to dissolve any buildup.
•
Overfill Protector should move up
and down freely about one inch.
If it does not move, lift and clean
underneath.
Cleaning the Interior
Use Frigidaire ReadyClean
Cleaner Tablets (Item # 10FFPRDT01)
to clean and freshen the interior of
the dishwasher. Place one tablet in the
bottom of the empty dishwasher tub (not
the dispenser), run a rinse cycle, leave
washer door closed for at least 6 hours,
then resume normal use. One tablet used
monthly is recommended for best results.
Dishwasher
®
Advertisement
