Husqvarna 967324001-00 Operator's Manual page 23

MAINTENANCE
To remove cables, reverse order
1. Remove BLACK cable first from chassis and
then from the fully charged battery.
2. Remove RED cable last from both batteries.
CAUTION! Lead-acid batteries generate
explosive gases. Keep sparks, flame and
smoking materials away from batteries. Always
wear eye protection when around batteries.
IMPORTANT INFORMATION The mower is
equipped with a 12-volt negative grounded
system. The other vehicle must also be a
12-volt negative grounded system. Do not use
your mower to start other vehicles.
IMPORTANT INFORMATION Do not try to
open or remove caps or covers. Adding or
checking level of electrolyte is not necessary.
Always use two wrenches for the terminal
screws.
The mower is equipped with a maintenance
free battery. Servicing is not necessary. Periodic
charging of the battery with an automotive type
battery charger will extend its life.
• Keep battery and terminals clean.
• Keep battery bolts tight.
• See chart for charging times.
STD STATE
BATTERY OF
CHARGE
50 Amps
12.6V 100%
12.4V 75%
12.2V 50%
12.0V 25%
11.8V 0%
APPROXIMATE CHARGING TIME*
TO FULL CHARGE AT 80
Maximum Rate at:
30 Amps 20 Amps
- FULL CHARGE -
20 min. 35 min. 48 min.
45 min. 75 min. 95 min.
65 min. 115 min. 145 min.
85 min. 150 min. 195 min.
WARNING! Do not short battery
terminals by allowing a wrench or other objects
to contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to
prevent sparks from accidental grounding.
Cleaning battery and terminals
Corrosion and dirt on the battery and terminals
can cause the battery to lose power.
1. Disconnect BLACK battery cable first, then
the RED battery cable and remove the battery
from the machine.
2. Flush the battery with plain water and dry.
3. Clean terminals and battery cable ends with
wire brush until shiny.
4. Coat terminals with grease or petroleum jelly.
5. Reinstall battery.
Replacing battery
1. Lift seat and push forward.
2. Using two 1/2" wrenches disconnect BLACK
battery cable then RED battery cable.
3. Position deck to lowest setting.
4. Front underside of frame, remove the nuts
securing the battery hold-down.
5. Carefully remove the battery from the mower.
6. Install new battery with cable terminals routed
to the center of the battery.
7. Reinstall battery hold-down and attach with
nuts removed in Step 4.
F
O
8. Reconnect RED battery cable to positive (+)
battery terminal with bolt and hex nut.
10 Amps
9. Connect BLACK grounding cable to negative
(-) battery terminal with remaining hex bolt
and hex nut
90 min.
10. Replace terminal boot cover. Lower the seat
180 min.
280 min.
370 min.
23