Cleaning And Maintenance - cecotec CONGA 7490 ULTIMATE GENESIS Instruction Manual

ENGLISH

4. CLEANING AND MAINTENANCE

Cleaning the main brush
- The main brush spins at top speed and helps pushing the dirt into the suction mouth.
This brush is in contact with the floor, and therefore with dirt, so it can wear out overtime,
affecting negatively to the cleaning efficiency. For this reason, it is suggested to replace the
main brush after a maximum of 320 hours or less.
1. Slightly press the main brush frame's tabs to open the main brush compartment and
remove it. Fig. 10
2. Remove hair, lint, and other dirt trapped in the brush and around the shafts with the help
of the self-cleaning brush. Fig. 11
3. Clear and clean the robot vacuum cleaner's suction channel.
4. Reinstall the main brush and its frame.
Recommendation
It is recommended to clean the main brush once a week with the help of the self-cleaning
brush.
Side brush. Fig. 12
The side brush is designed with many bristles that push dirt into the suction mouth and
thoroughly clean edges and corners. This brush may wear out overtime, which will negatively
affect cleaning efficiency.
Recommendation
- It is recommended to clean the side brush once a week with the help of the self-cleaning
brush.
- Remove the fixing screw and pull out the side brush.
- After cleaning, put the brush back in position and fix it again with the screw.
Recommendation
To ensure perfect cleaning, it is recommended to change the side brush every 3 months
(depending on frequency and type of use).
Mixed tank. Fig. 13:
- Remove the mixed tank.
- Open the mixed tank cover and empty it.
- Use the self-cleaning brush to clean the inside of the mixed tank.
- You can clean the dust compartment with water, without immersing the tank. Male sure
the tank is completely dry before re-installation to prevent water to reach the motor and
damage the robot vacuum cleaner.
- Reinstall the mixed tank on the robot vacuum cleaner.
60