Installing An Accessible Drive - Fujitsu CELSIUS W4 Series Operating Manual

System expansions

Installing an accessible drive

► Open the casing (see
► If you are installing the drive in the upper bay and a cover (optional) is
already in place, please remove it.
or
► If you are installing the drive in the lower bay and a cover (optional) is
already in place, please remove it.
► Break out the pre-stamped metal cover on the drive bay.
► Fit the drive cover for the 5
the 5 / inch drive", Page
1
4
Do not throw away the cover. For cooling and protection against fire you must refit the
cover if you remove the drive again later (see
► Slide the accessible drive into the casing until it snaps in place (1).
► Connect the cables to the drive. Make sure the polarity is correct.
► Close the casing (see
It may be necessary to modify the entry for the drive in the BIOS Setup.
38
"Opening the casing", Page
/ inch drive (see
1
4
37).
"Closing the casing", Page
35).
"Fitting the drive cover for
"Removing an accessible drive", Page
1
36).
Fujitsu Technology Solutions
39).