Related Manuals for Hunter Port Haven 50823
Summary of Contents for Hunter Port Haven 50823
- Page 1 Port Haven Installation Manual Model: 50178 Matte Black 50823 Fresh White Fan weight ±2 lbs: 16.8 lbs (7.6 kg) ©2020 Hunter Fan Co. PG3802 r011720...
- Page 2 - All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 3 We recommend that you pull everything out of the box and lay it out. We have grouped the drawn components below with the hardware you’ll need for those Hunter Pro Tip: parts. The screws below are drawn to scale to make it easier to identify what piece of hardware is needed to install each component.
-
Page 4: Choosing The Right Installation Location
Installing the Ceiling Bracket You have two options for installation. Pick which one works best for your location. Remove any existing bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box. Do this first! -
Page 5: Hanging The Fan
1886 Installing the Top Housing 3/8” Top Housing Screw 6” Grounding Screw Grounding Screw The wires can be cut, but leave at least 6” extending from the top of the canopy. Install the top housing screws. Install the grounding screw in the smaller screw hole. -
Page 6: Wiring The Fan
If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualified electrician. You are going to need these: Hunter Pro Tip: Here is how to connect the wires: 4 Wire Nuts (these are in the... -
Page 7: Installing The Canopy
1886 Installing the Canopy 2 of 3 Canopy Screws Swing the fan up to align the Hold the canopy up with the screw holes canopy screw holes with the aligned. Partially install two canopy screws, mounting holes on the ceiling plate. found in the hardware bag, into the holes opposite the ceiling plate hooks. -
Page 8: Assembling The Light Kit
1886 Installing the Blades Blade Arm Screw Ridge Lightly attach the blade arms to the motor with IMPORTANT screws found in the hardware bag, then securely tighten after both screws are attached. NOTE: The blade arms should be mounted with Repeat x4 Note: the ridge facing downward. - Page 9 1886 Installing the Bulbs and Glass Notch Attach the globe by lifting and Install the included bulbs turning clockwise one third of a into the sockets. When full turn of the glass until it stops. necessary, replace with NOTE: Check to ensure WARNING bulbs of same wattage.
-
Page 10: Troubleshooting
Hunter instructions, accidental damage caused by the fan owner or related parties, Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. modifications to the fan, improper or incorrectly performed maintenance or repair,...
Need help?
Do you have a question about the Port Haven 50823 and is the answer not in the manual?
Questions and answers