lynx System Developers IdentiLynx SR Quick Start Manual

IdentiLynx SR & HRS Full-Frame Video Cameras
Verify that your IdentiLynx Full-Frame video system contains the components pictured below.
If not, or if you need additional help, please call: USA 978 556 9780 or email support@finishlynx.com.
Item Description
IdentiLynx Camera
and Tripod
Protective Case
10' (3 meter)
Ethernet Cable
Items not included
•
Computer (laptop recommended) running Microsoft Windows. Your computer needs: one available serial port,
or USB port, and one available Ethernet port.
•
(Recommended) PoE+ Gigabit Hub/Switch
•
(Recommended) UPS Battery Backup
Introduction
In this quick start guide, you will learn how to set up and configure the IdentiLynx camera with your FinishLynx timing
system and play back full-frame video captured at the finish line.
NOTES: Lynx recommends a
the IdentiLynx camera to your timing system.
The new IdentiLynx cameras are a different design from the older models. The Ethernet port in the back of
the camera supports XLR to RJ-45 connectors for weatherproof connection. Failure to use this connector
may lead to water infiltration which could damage the camera.
To learn how to install the connector on your Ethernet cable, go to:
Assembly Instructions.
The IdentiLynx SR/HRS cameras require FinishLynx version 12.10 or later to operate. Download the software from
the Lynx Flash Drive included with the camera, or download from the website:
www.finishlynx.com/product/software/finishlynx-results-software/
IdentiLynx SR/HRS Quick Start Guide
Quick Start Guide
ID
IdentiLynx SR/HRS
SE520
C10BT-10
PoE+ Gigabit hub/switch
Lynx System Developers, Inc.
Item
and a Gigabit network card
www.neutrik.com/en/product/ne8mx-b
Description ID
Power Injector
for Power- IDL-PoE
over-Ethernet
Power-over-
Ethernet Included with
Power Supply IDL-PoE
Connector
100' (33 meter)
Ethernet Cable
with
WPCAT6-100
Weatherproof
XLR-RJ45
connector
as a minimum when adding
to find the
Page 1 of 4