Wireless Lan - NEC LT380 Setup Manual

5-2. Wireless LAN

When inserting the wireless LAN card into the PC card slot of the projector, configure the LAN
settings in the "PC Card" page of "LAN Mode" selected from On-Screen Menu.
Flow of Setting
1
Step Display "PC Card" page of "LAN Mode".
2
Step Select "Profiles".
3
Step Enable or disable "DHCP".
If "Disabled" (without check mark)
4
Step Input "IP Address".
5
Step Input "Subnet Mask".
Step 6 Input "Gateway".
7
Step Input "DNS Configuration".
Step 8 - 16 Setting of "Advanced".
8
Setting of "Network Type".
9
Select SSID in "Site Survey".
10 Input "SSID" (if necessary).
11 Select "Mode" (if necessary).
12
Select "Channel" (if necessary).
Step
Step
Step
If "Enabled" (with check mark)
13
Setting of "WEP"
14
Select the number of bits of "WEP".
15 Select "Key Select".
16 Set "Key 1 to Key 4".
17
Finalize "Advanced".
18
Reconnect the network.
19
Finalize the setting.
5. Setting the LAN Setting of Projector
If "Easy Connection" is selected
5
15