Summary of Contents for DeLonghi Magnifica ESAM3200.S
Page 1
BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE...
Page 18
ElECTRICAl REqUIREMENTS Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.
Contents settInG WAteR HARDness ....16 Measuring water hardness ......16 IntRoDUCtIon ........7 Set water hardness ......... 16 Symbols used in these instructions ....7 settInG tHe teMPeRAtURe ....16 Letters in brackets ..........7 Troubleshooting and repairs ......7 teCHnICAL sPeCIFICAtIon ....
IntRoDUCtIon sAFetY Thank you for choosing the ESAM3 automatic Fundamental safety warnings coffee and cappuccino maker. We hope you enjoy using your new appliance. Danger!! Take a few minutes to read these instructions. This is an electrical appliance and may therefore This will avoid all risks and damage to the ma- cause electric shock.
DesIGnAteD Use DesCRIPtIon This appliance is designed and made to prepare Description of the appliance coffee and heat drinks. All other use is consid- (page 3 - ered improper. A1. Grinding adjustment knob This appliance is not suitable for commercial A2.
PReLIMInARY CHeCKs • You should customise water hardness as soon as possible following the instructions Checking the appliance in the section “Setting water hardness” on After removing the packaging, make sure the page 16. product is complete and undamaged and that all accessories are present.
coffee spouts and is collected in the drip tray un- 15min 30min derneath. Avoid contact with splashes of water. • To turn the appliance on, press the button (fig. 4). The lights flash while the appliance is heating up and 3.
wise, otherwise the coffee may be delivered tips for a hotter coffee: For hotter coffee, you should: too slowly (a drop at a time), particularly • before delivering the coffee, perform a rinse when making two cups of coffee. cycle by pressing the button. Hot water selecting the quantity of coffee in the cup is delivered from the spout, heating the inter- Adjust the coffee quantity selection knob (B9) to...
Making coffee using pre-ground coffee To avoid milk with poor froth or large bub- bles, always clean the cappuccino maker as Important! described in the section “Cleaning the cap- • Never add pre-ground coffee when the ma- puccino maker after use”. chine is off or it could spread through the inside of the machine and dirty it.
as far as it will go. Delivery begins. Danger of burns! 4. Stop by turning the steam knob to the 0 posi- Avoid contact with splashes of water. tion. Cleaning the cappuccino maker after use. Please note: Clean the cappuccino maker each time you use it • If “Energy Saving” mode is active, you may to avoid the build-up of milk residues or block- have to wait a few seconds before the hot...
oughly to remove all residues left on the bot- Cleaning the water tank 1. Clean the water tank (A12) regularly (about tom. once a month and whenever you replace the Important! water softener filter, if provided) with a damp When removing the drip tray, the grounds con- cloth and a little mild washing up liquid.
4. Wait for the lights to come on steadily. Important! Danger of burns! Hot water containing acid flows from the cap- puccino maker. Avoid contact with splashes of water. 5. Press the button and hold it down for at least 5 seconds to confirm that you have added the solution and begin the descaling Please note! procedure.
settInG WAteR HARDness settInG tHe teMPeRAtURe light comes on after a period of time To modify the temperature of the water used to established according to water hardness. make the coffee, proceed as follows: The machine is set by default for a hardness val- 1.
MeAnInG oF LIGHts DURInG noRMAL oPeRAtIon LIGHts DesCRIPtIon MeAnInG The lights flash The coffee maker is not ready to make coffee (the water has not yet reached the ideal temperature). Wait for the lights to come on steadily before making coffee The lights are on steadily The coffee maker is at the right tempera- ture and ready to make coffee...
MeAnInG oF tHe ALARM LIGHts LIGHts DesCRIPtIon MeAnInG WHAt to Do The light is on Insufficient water in tank Fill the tank with water and/or in- or tank not correctly in sert it correctly, pushing it as far as steadily place it will go until it clicks into place.
LIGHts DesCRIPtIon MeAnInG WHAt to Do The lights flash The coffee maker has just Press the word PUSH on the infu- been turned on, the infu- ser until it clicks into place. alternately ser is not inserted correct- Make sure the two red buttons ly and the service door is have snapped out.
Page 36
PRoBLeM PossIBLe CAUse soLUtIon Coffee does not come • The spouts are blocked. • Clean the spouts with a toothpick. out of one of the spouts. The coffee does • The holes in the spouts are clogged with • The coffee guide inside the service door dry coffee dust is blocked and cannot swing. not come out of the spouts, but from •...
Need help?
Do you have a question about the Magnifica ESAM3200.S and is the answer not in the manual?
Questions and answers