Samsung AE044MXTPEH Service Manual page 70

Setting the option
1 Press and hold K2 to enter the option setting. (Only available when the operation is stopped)
– If you enter the option setting, display will show the following. (If you have set the 'Emergency operation for compressor
malfunction' , 1 or 2 will be displayed on Seg 4.)
– Seg 1 and Seg 2 will display the number for selected option.
– Seg 3 and Seg 4 will display the number for set value of the selected option.
2 If you have entered option setting, you can shortly press the K1 switch to adjust the value of the Seg 1, Seg 2 and select the
desired option. (Refer to pages 71~73 for the Seg number of the function for each option)
Example)
3 If you have selected desired option, you can shortly press the K2 switch to adjust the value of the Seg 3, Seg 4 and change the
function for the selected option. (Refer to pages 71~73 for the Seg number of the function for each option)
Example)
4 After selecting the function for options, press and hold the K2 switch for 2 seconds. Edited value of the option will be saved when
entire segments blinks and tracking mode begins.
CAUTION
• Edited option will not be saved if you do not end the option setting as explained in above instruction.
• While you are setting the option, you may press and hold the K1 button to reset the value to previous setting.
• If you want to restore the setting to factory default, press and hold the K4 button while you are in the option setting mode.
– If you press and hold the K4 button, setting will be restored to factory default but it doesn't mean that restored setting is saved.
Press and hold the K2 button. When the segments shows that tracking mode is in progress, setting will be saved.
Optional item Input unit
Cooling capacity correction
Heating capacity correction
Current restriction option Individual
Defrost temperature
correction
Channel address
Energy saving mode
64
→
→
SEG1 SEG2
Main 0 0
Main 0 1
0 2
Main 0 3
Main 0 4
Main 0 5
SEG3 SEG4
0 0 7 to 9
0 1 5 to 7
0 2 9 to 11
0 3 10 to 12
0 0 Standard high-pressure target [Default]
0 1 High-pressure target : standard-0.2MPa
0 2 High-pressure target : standard-0.1MPa
0 3 High-pressure target : standard+0.1MPa
0 0 All electric current [Default]
0 1 All electric current I_Down_OP1
0 2 All electric current I_Down_OP2
0 3 All electric current I_Down_OP3
0 0 Defrost temperature constant (α) = MID
0 1 Defrost temperature constant (α) = MID
0 2 Defrost temperature constant (α) = LOW1
0 3 Defrost temperature constant (α) = LOW2
A U Automatic address setting
Automatic address setting
00 to 15
0 to 15
0 0 Disabled (default)
0 1 Enabled
Remarks
Samsung Electronics