Toshiba 1TN Quick Installation Manual page 12

CAUTION: The wall mounting bracket must be installed by an insured, qualified, professional
installer who is familiar with building construction methods, building materials, building codes,
electrical codes, fire codes, and local laws governing public access areas.
CAUTION: It is imperative that the wall mounting bracket be securely and permanently
mounted to the wall. In addition to the printer weight, the wall mounting bracket must maintain
its security and attachment in the event the unit is knocked, bumped, or otherwise abused. If the
wall mounting bracket is not securely attached to the wall, the unit might fall and be damaged
and might also cause injury to others.
CAUTION: There is a wide variety of types of wall construction, age and condition. After
reviewing the conditions onsite, the installer must make the final judgment as to the suitability
of the existing wall material to determine if additional bracing or supports are required.
Attaching the wall mounting bracket involves making minor modifications to the building
construction. Be sure to observe proper safety precautions to prevent injury. Unforeseen
hazards, for example, natural gas and power lines, can exist when drilling and cutting into walls.
Note: Fasteners are not included with the wall mounting bracket and must be supplied by the
installer. The type of fasteners required is dependent on the type and condition of the wall
construction. The heads of the fasteners must be flush or below the outer front surface of the
wall mounting bracket.
Note: Mount the wall mounting bracket to a flat, sturdy, structurally sound column or wall
surface. The mounting surface must be flat, or shimmed with flat washers to be flat, in the area
under the wall mounting bracket mounting hole, so that the wall mounting bracket stays flat and
is not warped by the installation. After installation, check to make sure that the wall mounting
bracket is firmly and securely mounted to the wall.
Note: Before installing the wall mounting bracket, ensure that all applicable building and
electrical codes and accessibility requirements and guidelines are followed. Compliance with
local building codes, electrical codes, and governing laws should take precedence over this set of
instructions.
To mount the printer to the wall:
1. Position the wall mounting bracket on the wall.
Note: Position the bracket so that the installed printer will not extend more than 102 mm (4
in.) into a walkway, hallway, corridor, passageway, or aisle.
2.
Pay close attention to the orientation of the arrow
make sure that the arrow is pointing in the upward direction (see Figure 3).
A
Figure 3. Wall mounting bracket
12
TCx Single Station Printer Installation and Service Guide
on the wall mounting bracket and
A