Hella VENTUR Pergola Installation Instructions Manual page 88

Installation Instructions
Installation of the VENTUR SIDE
88 Subject to technical modifications – Date of Issue
September/2023
As shown, the cable is
without loop and laid at the
shortest distance to the exit
(upper notch of the basic
profile). At that, the cable
must run behind the retaining
ring to the motor bearing
(eyelet and cable are at the
same position).
To prevent damage to the
cable, it may not come in
contact with the cover.
Insert the zip fastener into
the PVC guiding profile.
With guide rail 55x75 mm:
Adjust the position of the
lower locking pieces.
Tighten the screws of the
locking pieces at the position
desired. Vertically and
horizontally adjustable (see
chapter "Fine adjustment of
the locking device of the front
rail profile").
Legend
Lower the cover in the guide rail
1
Adjusting the locking at the bottom -
2
locking pieces