CONTENTS 13.4 Cleaning the drip tray and condensate tray .16 13.5 Cleaning the inside of the coffee machine ...16 1. FUNDAMENTAL SAFETY WARNINGS .....7 13.6 Cleaning the water tank ......16 2. SAFETY WARNINGS ........8 13.7 Cleaning the coffee spouts ......17 2.1 Symbols used in these instructions ....8 13.8 Cleaning the pre-ground coffee funnel ..17 2.2 Designated use ..........8...
1. FUNDAMENTAL SAFETY WARNINGS • The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
2. SAFETY WARNINGS Any other use is considered improper and thus dangerous. The manufacturer is not liable for damage deriving from improper 2.1 Symbols used in these instructions use of the appliance. Important warnings are identified by these symbols. It is vital to respect these warnings.
If the power socket does not match the plug on the appliance, During rinsing, a little hot water comes out of the coffee spouts have the socket replaced with a suitable type by a qualified (A19) and is collected in the drip tray (A15) underneath. Avoid professional.
- Energy saving, To select the operation you require, proceed as follows: - Beep, 1. Press (B5) to enter the "Settings" menu; - Default beverages, 2. Press the selection arrows (B2 and B4) until "Maintenance" - Default values; is displayed between the two dotted lines; Statistics.
3. Press OK (B3) to confirm and select the required item with The display goes back to the previous screen. the selection arrows. Then follow the instructions for each • Default beverages: setting. Use this function to reset the default values for all the beverag- •...
If the coffee is delivered too slowly or not Beverages with coffee selectable from the at all, turn one click clockwise towards 7. (B12) For fuller bodied creamier coffee, turn ≃ 120 ml from ≃80 Espresso one click anticlockwise towards 1 (do not to ≃180ml Lungo turn more than one click at a time other-...
≃ 120 ml EXTRA LIGHT Espresso Lungo ≃ 30 ml Ristretto LIGHT 5. Preparation begins. The beverage selected appears on the display together with a progress bar which gradually fills MEDIUM as preparation proceeds. STRONG Important! Making LONG coffee Halfway through preparation, the message "Add pre-ground X-STRONG coffee"...
the milk a creamy frothy appearance and making it more 11. “ ” PROGRAMMING AND SELECTING voluminous; you can select beverages customised to your per- 9. For a creamier froth, rotate the container with slow move- sonal tastes. If the beverages have not yet been programmed, ments in an upward direction;...
13. CLEANING To clean (with the machine on): • Remove the drip tray (A15) (fig. 19), empty and clean. 13.1 Cleaning the machine • Empty the grounds container (A11) and clean thoroughly The following parts of the machine must be cleaned regularly: to remove all residues left on the bottom.
2. Remove the filter (C4) (if present) and rinse with running 9. Close the infuser door; water; 10. Put the water tank back. 3. Replace the filter (if provided), fill the tank with fresh water and replace the tank; 14. DESCALING 4.
coffee spouts. A series of rinses and pauses is performed The descale message is displayed after a period of time estab- automatically to remove all the scale residues inside the lished according to water hardness. coffee machine; The machine is set by default for a hardness level of 4. The ma- After about 35 minutes, descaling stops;...
7. "Hot water, Confirm?": Position a container under the cap- Please note puccino maker (A20) (min. capacity: 500ml), then press The filter lasts about two months if the appliance is used nor- mally. If the coffee machine is left unused with the filter in- 8.
19. DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY Fill tank Insufficient water in the tank (A17). Fill the tank with water and/or insert it correct- ly, pushing it as far as it will go until it clicks into place (fig. 3B). Insert tank The tank (A17) is not correctly in place.
Page 22
Press OK (B3) and deliver water from the cap- Water circuit empty The water circuit is empty. Fill water circuit puccino maker (A20) until it flows out normal- Hot water ly. If the problem persists, make sure the water Confirm? tank (A17) is fully inserted.
20. TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Services. PROBLEM POSSIBLE CAUSE REMEDY The coffee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot water (Please note: you can use the hot water function).
The frothed milk has large The milk is not cold enough or is not You should ideally use skimmed or semi- bubbles semi-skimmed skimmed milk at refrigerator temperature (about 5°C). If the result is not as you wished, try changing brand of milk. The milk is not frothed The cappuccino maker (A20) is dirty Clean as described in section “10.2 Cleaning...
Need help?
Do you have a question about the ECAM35 35 Series and is the answer not in the manual?
Questions and answers