Table of Contents
Advertisement
If the enclosure height is above 33 1 / 16 " (840mm)
use "o" and "p" labelled toe kicks together. Make
sure the slotted toe kick "p" is on the outside so
you can adjust height of the toe kick. Installation
should be done following the steps illustrated in the
figures A, B and C respectively.
1. Align the toe kick (o) and (p) (A).
2. Secure toe kicks to brackets with screws (t) after
adjusting the height of the slotted toe kick (p) (B).
3. Attach caps (s) as shown in the supply bags (C).
?
?
o
A
B
s
A
If the enclosure height is below
33 1 / 16 " (840mm) use only
"o" labelled toe kick (toe kick
without slots). Installation should
be done following the steps
illustrated in the Figures A, B and
C respectively.
1.Bend tabs on toe kick (o)
t
inwards (A).
2. Secure toe kick to brackets
with screws (t) as shown in the
supply bags (B).
C
3. Attach caps (s) as shown in
the supply bags (C).
7.4 INSTALLING THE OUTER DOOR
(DWT 54100 FBI, DWT 55100 FBI, DWT 55200
FBIWS, DWT 57500 FBI)
Measure the height and width of the enclosure
(Figure A) and the toe kick. Determine how big
the wooden door can be. For example if the height
is 33 7 / 8 " (860mm) and if the toe kick is 3 15 / 16 "
(100mm) the door can not be taller than 29 15 / 16 "
(760mm).
1. Prepare the wooden door with the mounting
brackets.
Height
: Height of the wooden door 30"
(760mm)
Width
: 23 ¼" to 23 ½" (592mm - 595mm)
Thickness
: ¾ " (19mm)
16
USA
A
o
p
B
t
C
s
Advertisement
Table of Contents
