TUISS Click2Fit Installation Manual

Fitting the blind
Friction plates are provided with the
fittings, but these are only necessary if you
find that the Click2Fit™ rail slips against
the wall of your recess once the blind is
fitted.
Hold the Click2Fit™ rail up against the top of the recess, then push the lever firmly
upwards until the rail snaps into place. If the rail is not quite tight enough then this can be
easily adjusted:
Situate the front lip
of the headrail into
the front of the
bracket.
To release the blind from the brackets at any point after installing, push firmly against the
blind's headrail to disengage it from the front of the bracket. At the same time, twist the
back of the headrail downwards to release it from the back.
Installation Guide
Click2Fit™
At the end of the rail opposite to the lever there is an adjustment
block that allows you to fine-tune the fitting of the rail. Use a
flat-head screwdriver to twist the small red plugs in toward the
centre of the rail. Slide the block out of the rail by a few millimetres,
then twist the red plugs back into their original position to fix the
block in place. Make small adjustments only, repeating as
necessary for a tight fit.
To fit them, peel the covers from
the sticky pads on the back, then
stick one to each end of the
Click2Fit™ rail, as shown.
Honeycomb Blinds
Push the back of the
headrail upwards to
lock it into the back
of the bracket.