How To Use - Remington protect&shine CI-75i Use And Care Manual

How to Use

Line Cord Safety Tips Heat Cautions
To insert plug, grasp it firmly and guide This multi-temperature curling iron has
it into outlet. been specially designed to be able to curl
The appliance has a polarized plug , so it very coarse, thick, hard-to-curl hair. Due to
will only fit into the outlet one way. (See this special application, the barrel of this
safety warnings for more details.) curling iron will be hotter on the HI (25-30)
To disconnect the appliance, grasp the settings than regular dual-heat curling irons.
plug and remove it from outlet. Do not Due to the extreme capabilities of this
pull or yank on the cord iron, the barrel will be very hot in the HI
or appliance. (25-30) settings, so extra care should be
taken when using.
Do not wrap the cord around the
appliance.
Keep unit away from contact with all
skin areas. Do not touch barrel with
Note: Before each use, inspect the line
fingertips.
cord for cuts and/or abrasion marks.
DO NOT OPERATE THE APPLIANCE IF
For shorter hair, place a thin plastic
THE LINE CORD SHOWS ANY DAMAGE.
comb between scalp and curling iron
barrel to avoid touching scalp.
Important
Place fingers of free hand on safety tip
During the first few minutes of initial use,
when you need more control for curling.
there may be a slight odor. This is normal
and will quickly disappear.
Test a small section of hair to determine
correct heat setting for your hair type.
6
Special Reheating Feature
This iron features solid-state electronic
circuitry with a heat sensor that detects
temperature loss and quickly boosts the
power to bring the heat level back to
optimum styling temperature. During use
the indicator light will repeatedly go
through cycles of flashing and becoming
steady as the appliance is constantly
bringing itself back to optimum styling
temperature.
Auto-off
After approximately one hour, the unit will
automatically shut itself off. To reactivate
the unit, press the ON/OFF switch.
Dual Voltage Use
This appliance contains a special electronic
circuit that automatically converts it for
worldwide usage–from 100 to 240 volts
AC, 50 to 60 Hz. Just plug it into the local
outlet and use it as normal; the styler will
automatically adjust to the local current.
(You may need an adapter to allow the plug
to fit into the local outlets, however.)
Get other manuals https://www.bkmanuals.com
How to Use
Hair should be clean, dry or nearly dry, and
free of tangles before using. (This iron can
also be used for quick touch-ups any time.)
1. Rest the iron on its stand on a smooth,
flat surface, and plug it in.
2. Press the ON/OFF switch, and the power
indicator light will flash.
3 Select a temperature according to
the type and texture of your hair.
4. With the heat control dial set at the
desired setting, allow the unit to
pre-heat. The power indicator light
will begin to flash, signaling that the
appliance is heating up. When the
appliance is heated the indicator light
will glow steadily.
7