Page 2
It is particularly important to use an RCD together with portable products that are plugged into an electrical supply not protected by an RCCB. If in doubt con- sult a qualified electrician. You may obtain a Residual Current Device by contacting your Sealey dealer. You must also read and understand the following instruc- tions concerning electrical safety.
3.3.4. Hinge down the tension arm and secure with the wire feed knob. (See section 3.4 re wire tension.) fig. 5 fig.7 fig. 6 EM130XT.V2, PM140XT.V2, PM150XT.V2 - 2 - 300704...
The following table is an estimated duration of cylinders based on a flow rate of 2 litres per minute. Actual duration will be dependant upon various job conditions including the operators welding technique. All times are therefore approximate. a) Refillable cylinder: /200 300g = 1 hour (refill service via Sealey dealers). b) Disposable cylinders: CO /100 390g = 1-1/4hours. CO /101 600g = 2 hours.
Build-up of spatter inside the gas cup can cause a short circuit at the contact tip which will result in either the fuse blowing on the printed circuit card, or expensive machine repairs. To keep the contact tip free from spatter, we recommend the use of Sealey anti-spatter spray (MIG/722307) available from your Sealey dealer.
Manufacturer and may be inspected, by a national We, the sole importer into the UK, declare that the products listed authority, upon request to Jack Sealey Ltd. below are in conformity with the following standards and directives. Signed by Mark Sweetman...