Husqvarna TS 142 Operator's Manual page 5

Steering
Wheel Insert
Steering Wheel
Adapter
Keys
Key(s)
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(1) 5/16" wrench
(2) 7/16" wrenches
(2) 1/2" wrenches
(1) 9/16" wrench
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
UNASSEMBLED PARTS
Steering Wheel
Steering
Wheel
Steering Boot
Oil Drain Extension
Utility knife
Tire pressure gauge
Pliers
(1) Large
Flat Washer
(1) Hex Bolt
Steering Mount
Slope Sheet
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton.
• Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels fl at.
• Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
5
(1) Lock
Washer
(4) Screws
Steering
Extension
Shaft
Battery
(2) Hex Bolts (2) Nut Keps