Sealey LPT7 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
WARNING! It is the user's responsibility to ensure the safe use of the blow torch. The following safety instructions are a guide only,
‰
and not an exhaustive list of potential hazards.
NOTE: The torch is for use with propane only.
Check torch and hose are in good condition and not damaged. Take immediate action to repair or replace damaged parts.
9
Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Use and store gas cylinders in accordance with all government and local authority regulations applicable to such items.
9
Turn the gas cylinder tap on first, then the regulator, and finally the torch tap. Reverse procedure to shut off.
9
Ensure nothing is standing or passing in front of the torch as the torch is ignited, and ensure you use a controlled source of ignition.
9
Ensure continuous ventilation is provided to the torch operating area, and that the area is clean and tidy.
9
The use of safety gloves is recommended. Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and
9
contain long hair.
Always keep an appropriate fire extinguisher at hand.
9
Ensure there are no non essential persons in the working area.
9
DO NOT point torch at yourself or others. DO NOT leave torch lying unattended. Place in an appropriate holder when pilot
8
only is operating, or to cool.
DO NOT use torch near flammable material, liquids, solids, or gases, and materials that may be accidentally ignited i.e. wood, cloth,
8
plastic etc.
DO NOT point the torch at the gas cylinder or hoses, and DO NOT use the torch to remove any ice that may form on the gas cylinder.
8
DO NOT heat items the substance of which (or surface residues) contain any materials that become hazardous when heated.
8
DO NOT operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT touch the torch or the work-piece until all parts have completely cooled.
8
DO NOT allow untrained persons to ignite or use the torch.
8
DO NOT leave the torch operating when unattended.
8
DO NOT try to make the torch "nozzle hole" larger.
8
Ensure the torch is correctly turned off when not in use.
9
WARNING! If the torch is used for prolonged periods at maximum power, ice may form on the propane cylinder. This is due to
‰
excessive evaporation. In such a case DO NOT use the torch to de-ice the cylinder.
LPT14
fig.1
2. INTRODUCTION
Suitable for heating and soldering. Control set includes gas valve and rapid flame control. Simply set the minimum flame level and by
activating the rapid flame control, the intensity of the flame is instantly adjusted. Supplied with 2m rubber hose, propane regulator and
selection of nozzles in metal storage case.
© Jack Sealey Limited
PROPANE TORCH KIT
LPT7,LPT14
MODEL NO'S:
LPT7
fig.2
Original Language Version
LPT7, LPT14 Issue: 4 (H,F) 30/05/23