Table of Contents
Advertisement
Notes
Truth Table (In case of external addition pull-up resistance to Vout terminal)
Light beam
Interrupted
Uninterrupted
Power supply line
In order to stabilize power supply line, connect a by-pass capacitor of
more than 0.01 F between Vcc and GND near the device.
Opaque board
Opaque board shall be installed at place 4mm or more from the top of elements.
(Example)
In case opaque board is the material with an low light blocking effect, There is a possibility of malfunctioning
because the light of LED transmits the opaque board. When you design the opaque board, please note transmittance
of infrared rays wave length (950nm) and the thickness of the opaque board.
And, please adjust the amount of transmitted light to 0.1% or less.
Cleaning
Please don't carry out immersion cleaning or ultrasonic cleaning to avoid keeping solvent inside case of this device.
Washing material
Dust and stain shall clean by air blow, or shall clean by soft cloth soaked in washing materials.
And washing material to clean shall be used the below materials only.
Ethyl alcohol, Methyl alcohol, Isopropyl alcohol
Connector connection
For the electrical connection to the connector terminal, please certainly use the connector specified
in this specifications.
Please avoid the connection by the soldering or welding which may damage the main body of the device,
and also avoid the contact by the clip and so on which may cause the malfunction by the contact failure.
Please avoid the use condition that t it always occurs he vibration
in the spot where the connector fits in by the resonance of the sensor and the harness.
It may cause the malfunction of the contact failure.
Put-in and pull-out of connector
The connection other than to the correct connection direction, forcing-into, and the pulling-out diagonally
(if being not put-in and pulled-out straight) may deform or break the connector terminal and/or housing,
which may cause the unusable state of the device.
Interference light
Because the upper, bottom and "Date Code" side are not covered by outer case,
please do not use this device under ambient light circumstances including infrared component.
Output
High
Low
4mm or more
6
GP1A173LCS3F
5
Sheet No.: OP14021EN
Advertisement
Table of Contents
