Table of Contents
Advertisement
Other Indication Symbols
2.3
Other Indication Symbols
The following other indication symbols are used on EDS500 series devices:
Symbol
Table 3:
Other indication symbols on EDS500 series devices
2.4
Applicable Standards and Directives for
Installation and Operation
The devices of the Hitachi Energy EDS500 series are produced in compliance with the relevant
regulations and standards.
According to IEC 60664-1 (DIN VDE 0110-1) Insulation coordination for equipment within low-
voltage systems – Part 1: Principles, requirements and tests, classification of the EDS500 series is
as follows:
• Pollution degree 2
Only non-conductive pollution occurs except that occasionally a temporary conductivity caused
by condensation is to be expected.
• Overvoltage category II
in accordance with the definitions in IEC 60364-4-44.
The owner of the devices and components is responsible to ensure that they are installed safely
and in compliance with the applicable local laws and regulations.
Standard
DIN VDE 0100
EN 50274 (DIN VDE 0660-514)
IEC/EN 60204 (DIN VDE 0113)
EN 50178 (DIN VDE 0160)
EN 50310 (DIN VDE
0800-2-310)
Table 4:
Standards
8
Type
Conformity
The CE mark on a product indicates that the manufacturer or
importer of that product affirms its compliance with the relevant EU
legislation and the product may be sold anywhere in the European
Economic Area (EEA).
Conformity
According to directive 2012/19/EU of the European Parliament and
of the Council of 4 July 2012 on waste electrical and electronic
equipment (WEEE), used electrical and electronics devices shall
no more be disposed to unsorted waste. The symbol of the waste
bin on wheels shows the necessity to separately collect electronics
waste. Therefore, this equipment should be disposed through the
designated systems of waste sorting if it is no longer used.
Erection of power installations with nominal voltages up to
1000 V AC or 1500 V DC.
Low-voltage switchgear and controlgear assemblies.
Protection against electric shock - Protection against uninten-
tional direct contact with hazardous live parts.
Safety of machinery; Electrical equipment of machines.
Part 1: General requirements
Electronic equipment for use in electrical power installations and
their assembly into electrical power installations.
Application of equipotential bonding and earthing in buildings
with information technology equipment.
Safety Instructions and Regulations
Meaning
Explanation
1KGT151042 V001 1
Advertisement
Table of Contents
