CONTENTS Important Safety Instructions .............................4 Product Information ................................9 Filling Water Tank ................................11 Fabric Steaming .................................13 Storage & Care ..................................15 Troubleshooting ..................................18 Warranty.....................................20 English...
READ ALL INSTRUCTIONS BEFORE USING IMPORTANT SAFETY INSTRUCTIONS This owner’s guide and any additional inserts are considered part of the product. They contain important information about safety, use, and disposal. Before using the product, please familiarize yourself with all operating and safety instructions. Please keep all documents for future reference and pass these documents on, together with the product, to any future owner.
Page 5
WARNING: Risk to Children and Impaired Persons Supervision is required during the installation, operation, cleaning and maintenance of this product by children 12 years of age and younger and anyone with reduced physical, sensory or mental capabilities. Children should be supervised to ensure that they do not play with the appliance, its parts and packaging material.
Page 6
- To reduce the likelihood of circuit overload, do not operate another high wattage appliance on the same circuit. - If an extension cord is absolutely necessary, a 15 ampere rated cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that the cord cannot be pulled or tripped over.
Page 7
and operating steam button. Do not operate unit if steam vents are blocked. - When filling unit, only distilled water should be used - other cleaning agents could damage unit or cause injury. - Do not attempt to use unit without properly filling Water Tank / Water Reservoir.
Page 8
SERVICING WARNING – To reduce risk of fire, electrical shock and injury to persons, observe the following: - If Steam Status Light does not illuminate when unit is plugged in and Button is set to “ON” position, unit is not operating normally. Immediately disconnect cord from power supply, then refer to troubleshooting guide on Page 18 of this manual for assistance.
PRODUCT INFORMATION The following features are included with your Handheld Garment Steamer. Carefully inspect the packing material for all parts listed below. To obtain possible missing parts, contact (833.800.8669) or (help@sihomecomfort.com). UNIT FEATURES Steam Nozzle Handle Water Tank On / Off Button Steam Status Light Steam Button Auto Shut-Off...
Page 10
STEAM NOZZLE Emits the flow of hot, penetrating steam. HANDLE Stays cool while providing maximum grip and comfort. WATER TANK Holds 10.14 oz. (300 ml.) of water. ON / OFF BUTTON STEAM STATUS LIGHT Illuminates red while steamer is heating and will illuminate green when ready to use.
FILLING WATER TANK 1. Turn OFF ( ) and unplug unit from power source. CAUTION: If unit has been in use, allow to cool (5 minutes for minimum cooling before removing Water Tank and adding water). 2. Remove Water Tank by twisting to the unlock position and pulling Water Tank away from the unit, see Figure 1.
FABRIC STEAMING CAUTION: When steaming any material for the first time, it is recommended that you test on a small inconspicuous area before proceeding. Do not use on synthetic fabrics such as 100% nylon or polyester, or other steam-sensitive materials. NOTE: Be sure the Water Tank has already been filled before following these steps.
Page 14
Steam Nozzle upward from bottom to top of garment. • Direct Steam Nozzle away from garment and smooth material with your free hand. • Repeat as necessary until garment is fresh and wrinkle-free. GENERAL STEAMING TIPS: • For most effective results, hold Steam Nozzle within 1/2” of fabrics, or press it directly against surfaces.
STORAGE & CARE PROPER STORAGE Preparing your steamer for storage is quick and simple. When you have completed your tasks, follow the steps listed below. 1. Push the Power On/Off Button (Steam Status Light will turn off) and unplug power cord. 2.
Page 16
The best way to minimize mineral build-up is to use distilled or de- mineralized water when using your steamer. In addition, it is recom- mended that the cleaning procedure below be followed at least once a month in order to remove any deposits that form. This will help to extend the life of your steamer and keep it functioning at its maxi- mum potential.
Page 17
remainder of the Water Tank’s content are steamed out. 6. Once Water Tank is drained, turn unit off and refill Tank with 10.14 oz. (300 ml) of fresh distilled water. Allow unit to steam until Water Tank is empty. Repeat as necessary until vinegar odor dissipates. 7.
TROUBLESHOOTING PROBLEM POSSIBLE CASE & SOLUTION Unit fails to heat up. Unit is not plugged in. Plug power cord into electrical Steam Status Light DOES outlet. NOT illuminate. The ON / OFF Button is pressed Off. Make sure the ON / OFF Button is pressed to turn the unit On and Steam Status Light is illuminated.
Page 19
TROUBLESHOOTING Steam output is weak or Mineral build-up in unit. Refer to STORAGE & CARE intermittent. section for details. Unit is spitting water with Use only with distilled water. residue. Mineral build-up in unit. Refer to STORAGE & CARE section for details. English...
SATISFACTION G U A R A N T E E Sharper Image, a division of Vornado Air, LLC. Sharper Image warrants to the original consumer or purchaser this Sharper Image® (“Product”) is free from defects in material or workmanship for a period of one (1) year from the date of purchase. If any such defect is discovered within the warranty period, Vornado, at its discretion, will repair or replace the Product at no cost.
Need help?
Do you have a question about the THREAD EXPRESS and is the answer not in the manual?
Questions and answers