Installing The Display Assembly (2-In-1) - Dell P138G Service Manual

Steps
1. Unroute the WLAN antenna cables from its routing guide.
2. Disconnect the IR camera cable from its connector on the system board.
3. Unroute the IR camera cable from its routing guide underneath the fan.
4. Peel the adhesive tape covering the eDP cable.
5. Remove the (M2x4) screw that secures the display cable bracket to the system board.
6. Open the latch and disconnect the eDP cable from its connector on the system board.
7. Disconnect the display cable from the connector on the system board.
8. Remove the two (M2.5x4) screws that secure the left-display hinge to the system board.
9. Remove the two (M2.5x4) screws that secure the right-display hinge to the system board.
10. Open the palm-rest assembly at an angle.
11. Gently slide the palm-rest assembly off the display assembly carefully.

Installing the display assembly (2-in-1)

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly for 2-in-1 and provides a visual representation of the
installation procedure.
80 Removing and installing components