ADG 7195
On button
Off button
Programme selection button
The selected programme is shown in the
window of the display.
Start button
Switches "on" when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Reset button
After pressing the Reset button, the selected
programme and the supplementary functions
are cancelled (except the detergent and water
hardness settings, see user instructions) and
must be reset. On releasing the button this is
confirmed by an acoustic signal.
Indicators
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Programme chart
Programmes
th
6
Sense
Pre-Rinse
Glass
Quickwash
1) 5) 6)
Bio
1)
Reference programme for energy label EN 50242;
2)
Refer to "User instructions";
3)
Programme data obtained in conformity with European
standard EN 50242. Values may vary in relation to usage,
e.g.: different loads, options, water temperatures - above
or below 15°C - as well as water hardness and power
supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Loading instructions
Automatic programme
recommended for routine
5)
40-70°C
washes, with dried-on food (for
example for EN 50242).
cold
Crockery to be washed later.
Light soiling, for example glasses
40°C
and cups.
Lightly soiled crockery with no
40°C
dried-on food.
50°C
Normally soiled crockery.
3)
Options
Time and failure display
Indicates in hours the time remaining until the start of
the wash cycle. Toward the end of the programme,
during the drying cycle, the display will indicate the time
remaining in minutes.
"F...." Identification of faults for service technician
"Delayed start" button
The wash cycle can be programmed to start after 1 - 24
hours. With each successive touch of the button, the
delayed start indicator increases by 1 hour, and after 24
returns to 00. Then press the Start button. The
dishwasher will start at the set time.
"Half load - Multizone" button
Load the upper or lower rack only.
This function can be used with any programme.
Press once = upper rack
(the indication lamp/symbol comes on)
Press twice = lower rack
(the indication lamp/symbol comes on)
Press 3 times = Off (half load function deactivated).
When washing without the top rack, press the "Half
Load" button twice, or "Lower rack wash" (the
corresponding LED/symbol comes on).
Set detergent
(when the appliance is used for the first time and when
using a different type of detergent)
Off indicator = detergent (powder, gel, tablets)
Left indicator =2 in 1 detergent
Right indicator = 3 in 1 / 4 in 1 detergent
Antibacterial rinse
This function adds an antibacterial rinse at the end of the
wash cycle, thereby guaranteeing a perfectly clean and
sanitized load. The lamp will light up when the function
is activated. If the temperature is not maintained during
the antibacterial cycle (e.g. if the door is opened and
remains open for a long time), the lamp will start
blinking to indicate that sanitation is not guaranteed.
Detergent
A
B
X
X
-
-
X
-
X
-
X
X
4)
The bacteria removal efficiency has been tested by the
Institut Pasteur de Lille (France), based on the NF
EN 13697 standard of November 2001.
5)
These programmes can be used with the Antibacterial
rinse option.
6)
Energy saving programme with prolonged drying cycle.
(We reserve the right to make technical modifications)
GB
4) 5)
2)
3)
Consumption
Litres
kWh
Minutes
7-17 0.99-1.58 65-170
4.0
0.03
14
10.0
0.85
100
10.0
0.65
30
13.0
1.05
195
5019 396 91634