Table of Contents
Advertisement
Escaping oil mist!
Risk of explosion and fire, health hazard, risk of environmental pollution!
▶
Depressurize the relevant machine/system part and repair the leak.
▶
Only perform welding work then the machine/system is depressurized.
▶
Keep open flames and ignition sources away from the axial piston unit.
▶
If axial piston units are located in the vicinity of ignition sources or powerful
thermal radiators, a shield must be erected to ensure that any escaped hydraulic
fluid cannot be ignited, and to protect hose lines from premature aging.
Electrical voltage!
Risk of injury from electric shock or risk of property damage!
▶
Always set up the relevant part of the machine/system so that it is free of
electrical voltage before you install the product or when connecting and
disconnecting plugs. Protect the machine/system against being energized.
High noise levels during operation!
Risk of hearing damage or hearing loss!
The noise emission of axial piston units depends on, among other factors,
rotational speed, working pressure and installation conditions. The sound pressure
level may rise above 70 dB (A) in certain application conditions.
▶
Always wear hearing protection when in the vicinity of the operating axial
piston unit.
Hot surfaces on the axial piston unit!
Risk of burns!
▶
Allow the axial piston unit to cool down sufficiently before touching it.
▶
Wear heat-resistant protective clothing, e.g., gloves.
Improper routing of cables and lines!
Risk of stumbling and property damage! Improper routing of cables and lines can
cause a risk of stumbling as well as damage to equipment and components, e.g.,
lines and plugs tearing.
▶
Always lay cables and lines in such a way that no one can trip over them, that
they do not become kinked or twisted, do not rub on edges and do not run
without adequate protection from sharp-edged ducts.
wARnInG
CAUTIOn
RE 91071-01-B/03.2015, A2FM/A2FE Series 70, Bosch Rexroth AG
Safety instructions
13/52
Advertisement
Table of Contents
