Panasonic SDR-S45EF Service Manual page 36

Service Manual
Diagrams and Replacement
Parts List
SD Video Camera
Model No.
SDR-S45EG SDR-S45GC
SDR-S45EF SDR-S45GA
SDR-S45EC SDR-S45GN
SDR-S45EP SDR-S45PU
SDR-S45EB SDR-S45PR
SDR-S45EE
Vol. 1
Colour
(S)...........Silver Type
Table of contents
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Voltage Chart ........................................................................... S-2
S2.1. Rear P.C.B. ........................................................................... S-2
S2.2. Monitor P.C.B. ....................................................................... S-2
S3. Block Diagram .......................................................................... S-3
S3.1. Overall Block Diagram .......................................................... S-3
S4. Schematic Diagram .................................................................. S-4
S4.1. Interconnection Diagram ....................................................... S-4
S4.2. Rear Schematic Diagram ...................................................... S-5
S4.3. CCD Schematic Diagram ...................................................... S-6
S4.4. EMC Schematic Diagram ...................................................... S-6
S4.5. DC BATT OP FPC Schematic Diagram ................................ S-7
S4.6. MONI FPC Schematic Diagram ............................................ S-8
S4.7. Monitor Schematic Diagram .................................................. S-9
S5. Print Circuit Board .................................................................. S-10
S5.1. Rear P.C.B. ......................................................................... S-10
VM1004027CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as "
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
S5.2. CCD P.C.B. ......................................................................... S-10
S5.3. EMC FPC P.C.B. ................................................................. S-11
S5.4. DC BATT OP FPC P.C.B. .................................................... S-11
S5.5. MONI FPC P.C.B. ................................................................ S-12
S5.6. Monitor P.C.B. ..................................................................... S-12
S6. Replacement Parts List .......................................................... S-17
S7. Exploded View ....................................................................... S-23
S7.1. Frame and Casing Section.................................................. S-23
S7.2. LCD Section ........................................................................ S-24
S7.3. Lens Section ....................................................................... S-25
S7.4. Packing Parts and Accessories Section .............................. S-26
S-1
" mark.
Circuit name being connected.
This signal is connected
FEP
OFTR
to the FEP schematic diagram.
Name of Signal
HAVE THE SPECIAL CHARACTERISTICS