Headlight Beam Adjustment - Renault KANGOO Vehicle User Manual

HEADLIGHT BEAM ADJUSTMENT

A
Switch A is used to adjust the height of
the headlight beams according to the
load.
With the dipped beam headlights lit,
press or lift switch A as many times as
is necessary to select the required po-
sition on the instrument panel.
Note: depending on the vehicle, when
the engine is started, the position se-
lected is displayed on the instrument
panel for approximately 30 seconds
and for 5 seconds each time switch A
is pressed.
(1/2)
Standard
chassis
Driver alone or with
front passenger
All seats occupied
Driver with
passengers
and luggage (or
load) reaching
the maximum
permissible all-up
weight
Driver without
passengers
and luggage (or
load) reaching
the maximum
permissible all-up
weight
The table below gives some examples. In all cases, adjust control A according to
the vehicle load so that the road can be seen and other drivers are not dazzled.
Examples of positions for adjusting
control A according to the load
Van version
Long Standard
chassis chassis
0 0 0
- - 0
- - 1
2 2 2
Estate versions
Long Long
chassis chassis
(5-seater) (7-seater)
0 0
0 1
1 1
2 2
1.181