Winix D480, D360 - Air Purifiers Manual
![]()
MODEL PART DIAGRAM
FRONT
![Winix - D480 - FRONT FRONT]()
BACK
![Winix - D480 - BACK BACK]()
WHERE TO USE
![Winix - D480 - WHERE TO USE WHERE TO USE]()
Allow 12 ~ 18 in. of space between TVs, radios, and other electronics
Electromagnetic interference from certain electronics may cause product malfunction.
Place indoors away from direct sun light
Direct exposure may cause product malfunction or failure.
Only place on hard, flat surfaces
Flimsy or slanted surfaces may result in abnormal noise and vibrations.
Allow at least 4 in. from walls
For maximum air flow.
CONTROL PANEL
![Winix - D480 - CONTROL PANEL CONTROL PANEL]()
- Smart Sensor
When in Auto Mode, the Smart Sensor detects the amount of impurities in the environment to adjust fan speeds. - Check Filter Indicator
LED light indicates when it is time to change the filter. - Filter Reset Button
After replacing the True HEPA Filter, use a small object such as a paper clip, to press and hold the reset button for at least 5 seconds until the Check Filter light turns off. - Auto Mode
The LED "Auto" light will indicate when Auto mode is activated. - When in Auto Mode the Fan Speed is automatically adjusted according to the indoor air quality. As the indoor air quality improves, the fan speed will automatically decrease. If the indoor air quality worsens, the fan speed will automatically increase.
- Auto Button
- Use the Auto Button to set the Air Purifier to Auto Mode.
- Air QualityIndicator
Color-coded LED indicates one of three levels of air quality. - BLUE (good), AMBER (fair), RED (poor).
- Fan Speeds
Indicates the current fan speed. - Sleep Mode
The LED "Sleep" light will indicate when Sleep mode is activated. When Sleep mode is activated: - The Air Quality Indicator LED light is disabled.
- The fan speed is automatically set to quiet.
- Fan Speed Button
Use the Fan Speed Button to set the desired Fan Speed. Fan Speeds cycle in this sequence: Low, Medium, High, Turbo, Sleep, Low. - Power Indicator
LED light indicates when the air-purifier is turned on. - Power Button
Turns the unit on or off. During the first 30 seconds of power, the Air Quality Indicator will cycle through Blue, Amber and Red colors. - Smart Sensor takes approximately 4 minutes to gauge the air quality in the environment before normal operation begins.
- Light Sensor
When in Auto Mode, the light sensor detects when to put the unit into sleep mode. - Detects the amount of ambient light in the environment.
3-STAGE AIR PURIFICATION
![Winix - D480 - 3-STAGE AIR PURIFICATION 3-STAGE AIR PURIFICATION]()
- Pre-Filter
Designed to catch larger airborne particles found indoors. - Activated Carbon Filter Sheet
Reduces VOCs and household odors from cooking, pets, and smoke. - True HEPA Filter
Captures 99.97%* of airborne allergens including; pollen, Mold spores, dust, pet dander, microbes, and smoke. *particles as small as 0.3 microns in size.
INITIAL OPERATION
- Remove the front panel by grasping its upper edge and gently pulling forward.
![]()
- Remove the Pre-Filter, then the bag of filters behind it.
![]()
- Remove the filters from the protective plastic bag.
![]()
- Install the filters until they fit securely in place.
![]()
- Pre-Filter (front)
- Activated Carbon Filter Sheet (middle)
- True HEPA Filter (back)
- After filters are installed close the front panel.
![]()
- Insert the power cord into an electrical outlet.
![]()
MAINTENANCE
When to Replace Filters ![]()
Filter | Indicator Light | When to service | When to replace |
Pre-Filter | none | Clean once every 14 days | Permanent |
Activated Carbon Filter Sheet | none | Can NOT be WASHED | Replace every 3 months |
True HEPA Filter | ![]() Check Filter | Lasts Approx. 12 months |
- When the Check Filter indicator LED is on, it is time to replace the True HEPA Filter.
- Intervals between filter replacement may vary depending on environment.
REPLACING FILTERS
![Winix - D480 - REPLACING FILTERS REPLACING FILTERS]()
After replacing the True HEPA Filter, press the RESET button for at least 5 seconds.
CLEANING CARE
Cleaning the Filters
![Winix - D480 - Cleaning the Filters Cleaning the Filters]()
Use a vacuum cleaner or soft brush to clean the Pre-Filter.
- If it is excessively soiled, rinse in room temperature water.
- Do not use detergent or soap.
- Allow the filter to completely dry for 24 hours or more before using.
- Intervals between filter cleaning may vary depending on the air quality.
NOTICE
- Do not use benzene, alcohol, or other volatile fluids, which may cause damage or discoloration.
- Do not use hot water over 104oF or volatile fluids such as paint thinner.
Cleaning the Exterior & Interior
![Winix - D480 - Cleaning the Exterior & Interior Cleaning the Exterior & Interior]()
Wipe with a soft damp cloth using room temperature water.
- Afterwards, wipe it down with a clean dry cloth.
Open the front panel and clean the interior with a vacuum cleaner.
- For optimal performance, clean every 1 - 2 months.
NOTICE
- When cleaning the unit, always unplug the power cord first and then wait until the unit has cooled down.
- Never disassemble, repair, or modify this unit yourself.
- Do not use flammable sprays or liquid detergents.
- Do not allow children to clean or maintain the unit.
- Before cleaning or maintaining, ensure unit is unplugged.
SAFETY AND CAUTIONS
Before operating this equipment, carefully read and follow these safety cautions
Ensure filters are inserted before running unit
Running the unit without filters can shorten the unit's life and cause electric shock or injury.
Be sure foreign objects are NOT inserted into the vents on the unit
Objects can include pins, rods, and coins.
Do not touch any part of the interior of the unit with wet hands
The high voltage may cause electric shock.
Ensure unit intake and outlet vents do not become blocked
Blockage may lead to increased internal temperatures causing product failure and derformation.
Do not use the unit as a step stool or place heavy objects on it
Personal injury may occur or product failure and deformation.
![]()
Follow these instructions to reduce the risk of serious injury or death and to reduce risk of damaging the unit.
- If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.
- This appliance is not intended for use by a person (including children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- This unit is not intended to be used to preserve documents or in art conservation.
- Do not pull on the power cord when unplugging the unit.
- Do not tie or knot the power cord when unit is in operation.
- If the unit becomes submerged in water, unplug it and contact customer service.
- Do not unplug or move the unit while in operation.
- Do not plug additional appliances into the same outlet or power supply.
- Do not touch the plug with wet hands.
- Unplug the unit when not in operation for extended periods of time.
- Do not place around heating elements.
- Do not use around mist or fumes from industrial oil or around large quantities of metallic dust.
- The cord can become damaged by forcefully bending, pulling, twisting, bundling, pinching or placing heavy objects on it.
- Do not install in any sort of motor or transport vehicle (trucks, boats, ships, etc.).
- Do not place in an area with excessive amounts of noxious gases.
- Do not place near any flammable materials (aerosols, fuel, gases etc.).
- Do not have the unit facing into wind or draft.
- Do not place below any electrical outlet.
- Do not place in excessively humid areas where the unit may become wet.
- To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
SAFETY INSTRUCTIONS
Thank you for purchasing a Winix air purifier. This product is for household use only.
IMPORTANT CAUTIONS FOR USING YOUR AIR PURIFIER
![]()
Follow the instructions in this manual to reduce the risk of electric shock, short circuit, and/or fire.
- Do not repair or modify the unit. All other repairs should be completed by a qualified technician.
- The plug for this unit is polarized with one blade wider than the other. Do not force the plug into an electrical outlet. Do not alter the plug in any way. If the unit does not fit into the outlet, reverse the plug. If it still does not fit, contact a qualified technician to install a proper outlet.
- Do not use if the power cord or plug is damaged or the connection to the wall outlet is loose.
- Use AC 120V only.
- Do not damage, break, forcefully bend, pull, twist, bundle, coat, pinch, or place heavy objects on the power cord.
- Periodically remove dust from the power plug. This will reduce the risk of shock due to humidity build up.
- Remove the power plug from the outlet before cleaning the unit. When removing the power plug, grasp by holding the plug itself, never hold by the cord.
- If the power plug is damaged, it must be replaced by the manufacturer or a qualified technician.
- Do not operate the unit when using indoor smokegenerating insecticides.
- Do not clean unit with benzene or paint thinner. Do not spray insecticides on the unit.
- Do not insert fingers or foreign objects into air intake or outlet.
- Unit will not remove carbon monoxide emitted from heating appliances or other sources.
IMPORTANT PRECAUTIONS FOR USING YOUR AIR PURIFIER
- Do not block the intake or outlet vents.
- Do not use near hot objects, such as a stove.
- Do not use where the unit may come into contact with steam.
- Do not use the unit on its side.
- Keep away from products that generate oily residue, such as a deep fryer.
- Do not use detergent to clean the unit.
- Do not operate without a filter.
- Do not wash and reuse the True HEPA Filter.
- Hold the handle on the back of the unit to transport.
- Do not hold by the front panel.
- Do not stick any small objects in the air outlet vents or fan.
FREQUENTLY ASKED QUESTIONS
The unit does not turn on at all.
- Is the plug securely attached to the outlet?
- Make sure the outlet has power going to it, and ensure the plug is secured.
- Is there a power outage?
- Check to see if other lights and electrical equipment are working and try again.
The unit doesn't work in Auto Mode.
- Has Auto Mode been selected?
- Press the Mode button until Auto Mode is selected.
- Is the sensor blocked or clogged?
- Wipe Smart Sensor with wet cloth, then dry.
It vibrates and makes a lot of noise.
- Is it running on a slanted or uneven surface?
- Move the unit to a hard, flat, even area.
The power plug and outlet feel hot.
- Is the plug securely plugged in?
- Make sure the plug is properly plugged into the outlet.
There is a strange smell.
- Is it being used in a place with a lot of smoke, dust, or odors?
- Clean the air intakes on either side and clean the Pre-Filter.
- Replace the Carbon and True HEPA filter.
The fan strength is weak. The unit is not purifying the air.
- Is the Check Filter indicator light on?
- Change the filters as required.
The display panel is dim.
- Is the Light Sensor blocked by debris?
- When Auto Mode is on, Sleep Mode is automatically activated when the Light Sensor detects that the room is dark.
PRODUCT WARRANTY
Winix warrants the parts of the machine to be free of defects and provides service and support for two (2) years from the date of purchase. If any part is found to be defective during the warranty period, Winix will repair or replace the defective part or unit.
The Limited Warranty will be honored under the following circumstances:
- If purchased through an authorized dealer or retailer.
- Purchase date is within the warranty period.
- The unit has been confirmed defective after troubleshooting with the Winix America Customer Service Team.
- The unit has been operated based on the user manual instructions.
- Genuine Winix Replacement Filters have been used in the unit.
Model Name | D480 / D360 |
Purchase Date | |
Warranty period | Two (2) years |
Place of purchase | |
- Additional costs for spare parts and/or shipping costs may apply during warranty inspections.
- This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, or unauthorized repair.
- The Limited Warranty does not include or cover the air cleaner's filters.
UNIT SPECIFICATIONS
Model Name | D480 | D360 |
Power Voltage | AC120V/60Hz |
Power Rate | 90 W | 65 W |
Verified Room Size | 480 sq.ft. | 360 sq.ft. |
Product Dimensions | 16.77 in(W) x 11.81 in(D) x 22.83 in(H) | 14.96 in(W) x 10.33 in(D) x 21.06 in(H) |
Product Weight | 17.6 lbs | 16.6 lbs |
Replacement Filter | Filter D4 / SKU: 1712-0100-00 | Filter D3 / SKU: 1712-0101-00 |
The exterior, design, and product specifications may be changed without prior notice to improve product performance.
![]() Change or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures. - Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or on experienced radio/TV technician for help.
|
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's license-exempt RSS(s). Operation is subject to the following two conditions: - This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
|
![]()
Contact Winix for product related inquiries and customer service
To expedite service, please specify the model name and number, the nature of the problem, your contact information, and your address.
![]()
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Winix D480, D360 - Air Purifiers Manual
Need help?
Do you have a question about the D480 and is the answer not in the manual?
Questions and answers