Ow To Lay Aoice Essage; Ow To Rase Aoice Essage - Ritron XT Series User Manual

RQX XT-Series Wireless Callbox
H P
OW TO LAY A
Recorded voice messages can be played back on the Callbox speaker for review.
42 1. Refer to
2. Loosen the (4) screws in the front corners of the case.
3. Separate the case front from the case back, leaving the batteries connected to the radio. Make sure the
unit has batteries installed.
NOTE: The voltage of the batteries must be greater than 6 VDC to record properly.
4. Press and release the ON/PTT button on the front of the unit to turn the radio on.
5. Press and HOLD the Program Button (See FIG-2 on page 8 for location). A "P" will appear on the program
display as you enter program mode and the radio will beep rapidly.
6. Release the program button after the beeping has stopped. The radio will emit a triple beep indicating that
the radio is in program mode and a hyphen will appear on the program display.
7. Click the Program button until the program display shows the Program Code "A". Pause—the radio will
sound a low tone and show a hyphen across the center of the display to indicate that it is ready to accept a
2-digit Play Recorded Message Code.
8. Enter the 1
desired number. Pause—the radio will sound a low tone and show a hyphen across the center of the
display to indicate that it is ready to accept the next digit.
9. Enter the 2
desired number. Pause—the radio sounds a low tone and will show a hyphen across the center of the
display to indicate that it is ready to accept the next digit.
10. Press and release the ON/PTT button to begin playback of the message. If the message has not been
recorded an error tone will sound and an "E" will appear on the display.
NOTE: An error tone will sound if you attempt to enter an incorrect code, an "E" will appear on the display.
Check the digits you are attempting to enter, then re-enter.
11. Once the message playback is complete a triple beep will sound and a hyphen will appear on the program
display. The radio is now ready to playback another message, or for another program entry.
12. Once you have played your final message, press the ON/PTT button a final time to turn the radio off. Turn
the radio back on for normal operation.
H E
OW TO RASE A
If you decide not to use a voice message that is already recorded, it can be easily erased via field programming. Follow the "How to
Play a Voice Message" instructions above using the Erase Code specified in
Have questions? Call 800-USA-1-USA (800-872-1872) or visit our website at www.ritron.com
V M
OICE ESSAGE
Table 5 to determine the two-digit Play Code and write it down.
st
digit of the Play Code by clicking the Program button until the program display shows the
nd
digit of the Play Code by clicking the Program button until the program display shows the
V M
OICE ESSAGE
........................................................
.......................................................
Table 5.
Voice Messages
34