Hypex Electronics UcD400 Getting Started

Hide thumbs Also See for UcD400:

Getting

Please take a moment to review the following details on your new Hypex UcD400 Amplifier, assembled by

Deer Creek Audio.

What's Included

● Assembled amplifier

● Printed test results

● Power cord

● Allen wrench for front cover

● Balanced XLR-to-XLR or TRS-to-XLR cables are preferred

● For single-ended RCA sources, use the cable configuration in diagram 1 below

● Requires a minimum 13 amp, 3-prong power cord

Started with Your Hypex

UcD400 Amplifier

(assembled by Deer Creek Audio)

Diagram 1. Cable configuration for single-ended RCA sources

Table of Contents

Do you have a question about the UcD400 and is the answer not in the manual?

Page 1 Getting Started with Your Hypex UcD400 Amplifier (assembled by Deer Creek Audio) Please take a moment to review the following details on your new Hypex UcD400 Amplifier, assembled by Deer Creek Audio. What's Included ● Assembled amplifier ● Printed test results ●...
Page 2 Break-in period When you first turn on the amplifiers, allow approximately 60 minutes warm-up time before critical listening. After the amplifiers have broken in for several hours, the starting warm-up time should be approximately 10 minutes. Amplifier gain setting Amplifier voltage gain is fixed at 26 dB typical. Installation Be sure to install your Hypex Class D amplifier with adequate ventilation.