Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Black & Decker BES702
Summary of Contents for Black & Decker BES702
- Page 1 BES702 www.blackanddecker.co.nz...
- Page 6 11 10...
-
Page 7: Intended Use
3. Personal safety a. Stay alert, watch what you are doing and use common Your BLACK+DECKER BES702 compound mitre saw has been designed for sawing wood, plastic and nonferrous metal sense when operating a power tool. Do not use a power tool while you are tired or under the influence only. -
Page 8: Safety Instructions For Mitre Saws
ENGLISH (Original instructions) A careless action can cause severe injury within a fraction studs, etc. Abrasive dust causes moving parts such as of a second. the lower guard to jam. Sparks from abrasive cutting will burn the lower guard, the 4. -
Page 9: Kerf Plate Replacement
(Original instructions) ENGLISH firm work surface before use. A level and firm work sur- fully down position. face reduces the risk of the mitre saw becoming unstable. Do not use cracked/bent/damaged/deformed saw blades. Plan your work. Every time you change the bevel or Replace the kerf plate when worn. mitre angle setting, make sure the adjustable fence is Kerf plate replacement set correctly to support the workpiece and will not... -
Page 10: Residual Risks
ENGLISH (Original instructions) Ensure the speed marked on the saw blade is at least BLACK+DECKER customer services for you nearest equal to the speed marked on the saw. service agent. Ensure that any spacers and spindle rings used are This mitre saw has been designed for sawing wood, suitable for the purpose as stated by BLACK+DECKER. - Page 11 (Original instructions) ENGLISH Features Labels on tool Some or all of the following pictograms along with the date This tool includes some or all of the following features. code are shown on the tool: 1. Bevel lock knob 2. Clamp lock screw Warning! To reduce the risk of injury, the user 3.
-
Page 12: Installing A Blade
ENGLISH (Original instructions) Removing the blade screw (21), as shown in figure B. Repeat the process on opposite side. Unplug the saw. Raise the arm to the upper position and push the guard Fig. C Bench mounting ( (13) up as far as possible. The mitre saw can be bolted with four bolts (5a) (not provided) Loosen, but do not remove guard bracket screw (12c) until to a level and stable surface using the bolt holes (5) provided... - Page 13 (Original instructions) ENGLISH Fig. M – M3 weight of the head and make sure to avoid it crashing over. Body and hand position ( Proper positioning of your body and hands when operating the Switch action ( miter saw will make cutting easier, more accurate and safer. Caution! Before plugging in the tool, always check to see that Never place hands near cutting area.
- Page 14 ENGLISH (Original instructions) This chart gives the proper angles for a variety tion that fits flat against the ceiling) of 52° and a bottom rear of shapes. angle (the part that fits flat against the wall) of 38°. The Bevel Setting/Type of Cut chart gives the proper settings Number of Sides Miter or Bevel Angle for cutting crown molding.
-
Page 15: Troubleshooting
After use Technical data After use, wipe off chips and dust adhering to the tool with a cloth or the like. BES702 Keep the blade guard clean according to the directions in Voltage 230V the previously covered section. Speed... -
Page 16: Ec Declaration Of Conformity
83 x 55 Max. dept cut at 90 ° Max. dept cut at 45 ° BES702 - Level of sound pressure according to EN 62841: (sound pressure) 97 dB(A), Uncertainty (K) 3 dB(A) (sound power) 109 dB(A), Uncertainty (K) 3 dB(A)