Advertisement
Rat cover installation (only for models with this part)
ATTENTION:
Please install before removing the transport fixing bolts, installation requires at
least two people to carry out the operation.
Before installing the rat cover, the tap must be turned off and the power cable
disconnected from the external power outlet, the inlet pipe from the inlet tap
and the drain pipe from the drain outlet.
The installation steps are as follows:
1. Remove the rat cover and remove the
double-sided adhesive stickers from
around the rat cover.
2. Tilt the washing machine backwards,
Slowly lower the washing machine onto
a cushioned surface, taking care that
the operating panel of the washing
machine is facing forward.
3. Place the sound-absorbing foam on the
rat cover towards the inside of the
washing machine, with the positioning
square holes on the left and the screw
holes around the backing plate aligned
with the screw holes in the base plate of
the washing machine. Press around the
rat cover to attach it to the base plate of
the washing machine.
4. Fix the left and right sides of the rat cover
and the rear side with special screws
(large round cap screws), after the fixing
is completed lift the washing machine
gently and place it smoothly.
This hole is for the side
Sound-absorbing foam
Rat cover
Side
Advertisement
