LGMG S0607EII Maintenance Manual page 50


The ground surface is solid and flat, without obstacles;

The environment in the working area allows for full lifting of the machine;

The maximum allowed wind speed is not greater than 12.5m/s (for S0607EⅡ/S0812EⅡ/S1012EⅡ) or
0m/s (for S0808EⅡ/S1212EⅡ/S1413EⅡ);

The battery SOC is sufficient;

The hydraulic oil level is between MIN and MAX marks;

The fork slideway between the platform and the chassis is fully lubricated;

No one will enter the platform during calibration;

The angle sensor and pressure sensor are free of damage, and the machine functions normally.
1) Drive the vehicle to a solid and flat area free of obstacles and suitable for this operation, and lower the
platform completely.
2) Wedge the two front steered wheels to prevent the machine from movement.
3) Turn the ignition switch to the neutral position.
4) Press the button
and input the password.
5) Select the Calibration menu, and press the button
status to "Enable".
△
! ATTENTION: Please contact the service personnel of LGMG to ask for password, if
required.
No-load calibration:
6) Enter the no-load calibration interface, and press and hold the button
automatic calibration process, in which the interface will display "Under no-load calibration..." Wait for
the completion of the calibration.
7) When the platform descends to the end and the buzzer stops, it indicates that the calibration is
completed.
Maintenance Manual of Scissors Mobile Elevating Work Platform
on the ECU, turn the ignition switch to GCU position, select the Settings menu
. Select the Weighing function, and change its
42
for 5s to activate the