Rimage Producer 7100N Reference Manual

Rimage Producer Family™
Replace a Recorder on a Rimage Producer 7100N and 8100N™
Use this procedure to replace a recorder in a Producer 7100N or Producer 8100N.
Rimage approved parts must be used for this process. The product warranty may become void if parts not approved by Rimage are
used; equipment or parts are tampered with, misused, neglected, or modified in any respect without the written consent of Rimage.
Notes:
•
The photos in this document are of either the Producer 7100N or Producer 8100N. Your system may not look exactly like
the system pictured.
•
The term "Producer IIIN" is used throughout this document to refer to the Producer 7100N or Producer 8100N.

Before you begin

1. Stop or pause all jobs.
2. Power off the embedded control center.
3. Power off the Producer IIIN.
4. Disconnect the power cord from the power outlet.

Remove the Recorder

1. Open the door.
2. Manually, slowly raise the lift arm to the top position.
3. From the front of the Producer IIIN, loosen the
thumbscrews (Qty. 2) that secure the recorder.
4. Pull the recorder out of the front of the Producer IIIN.
Important! Do not stretch the cables that are
connected to the back of the recorder.
Tip: The thumbscrews remain in the mounting
bracket.
112180_D

Required tools:

•
None required
Lift Arm
© 2008, Rimage Corporation
Operator
Thumbscrews
1