Panasonic KX-TVM50 Installation Manual page 38

2.3 Names and Locations
System Components
Run Indicator
Lights during normal operation; flashes when the system is off-line and cannot receive calls.
Alarm Indicator
Flashes when a system error is detected or while the VPS is preparing to shutdown. Lights when the
shutdown procedure is complete.
Reset Button
Resets the VPS.
Note
• Make sure the VPS is not in use before pressing the Reset Button.
Shutdown Button
Initiates the shutdown procedure. When the Alarm Indicator lights after pressing the Shutdown
Button, you may safely turn off the power switch.
Note
• Make sure the VPS is not in use before pressing the Shutdown Button.
Mode Switch
Used to perform one of several administration/service operations by selecting one of 16 switch
positions. After setting the Mode Switch to the appropriate position, shut down and restart the VPS.
Change the position of the switches by using the tip of a pointed object, such as a pen.
The available Mode Switch positions are shown in the following table. The black area in the switch
illustration indicates the direction of the switch.
Switch Position
0
1
2
3
4
5
6
38 Installation Manual
1 2 3 4
Puts the VPS in normal mode.
0
1
Reserved
Puts the VPS in DPT Integration mode. Auto Configuration starts and all
1 2 3 4
0
ports are set to provide Automated Attendant service.
1
Puts the VPS in DPT Integration mode. Auto Configuration starts and all
1 2 3 4
0
ports are set to provide Voice Mail service.
1
Reserved
Initialises the VPS. All settings are reset to their default values. Recorded
1 2 3 4
messages are erased. System Prompts (including customised prompts)
0
1
are preserved.
KX-TVM200/KX-NCV200 only
1 2 3 4
0
Puts the VPS in hard disk test mode.
1
Operation