If the distance sent forward from the peeling table is not appropriate, such as when the gap between labels
is large, finely adjust the pre-peeling.
When the fine adjustment setting is entered, a test operation for confirming an appropriate fine adjustment
value can be executed. If the leading edge of the paper that stopped normal rotation in this test operation
matches the leading edge of the peeling table, the actual pre-peeling forward / reverse amount is
appropriate.
When the test operation is executed after transitioning to the user mode after an error occurs, the test
operation is executed after returning to the error.
8.5.6
BACK FEED SPEED
STD
3 ips
LOW
2 ips
8.5.7
AUTO HEAD CHECK
OFF
Disables the auto print head check.
ON
Enables the auto print head check.
8.5.8
RIBBON NEAR END
OFF
Ribbon near end is not detected.
30m
Ribbon near end is detected when the remaining ribbon is 30-m long (Equivalent to ribbon
diameter of 38 mm)
70m
Ribbon near end is detected when the remaining ribbon is 70-m long (Equivalent to ribbon
diameter of 43 mm)
(Note): Since a detected remaining ribbon length has some margin of error, use the specified length as a
guide.
8.5.9
PAPER/RBN END
Stop immediately
Complete current
Notes:
1. Stop immediately:
When a label end or ribbon end is detected in the middle of printing, printing is immediately stopped.
When the printing is restarted, first the initial feed is performed, then the printer starts printing from the
unfinished label.
2. Complete current:
The "Complete current" is valid only when the ribbon save function is set to OFF. Even when the ribbon
save function is enabled, the behavior of the "Stop immediately" will be automatically performed
regardless of the setting. The printer behavior of the "Complete current" at the detection of label end and
ribbon end is as follows.
(1) Label end detection
Printer behavior
When a label end is detected in the middle of printing, the printer completes the half-finished printing
and stops when the next label is at the home position, displaying the error message.
When a label end or ribbon end status is detected, the printer stops immediately.
When a label end or ribbon end status is detected, the printer prints the current label
as far as possible, then stops.
76