Basic Operations - Kenwood NEXEDGE NX-248 Instruction Manual

SWITCHING POWER ON/OFF
Turn the Power switch/ Volume control clockwise to switch the
transceiver ON.
Turn the Power switch/ Volume control counterclockwise fully
to switch the transceiver OFF.
■ Transceiver Password
If your transceiver is password protected, the LED will light
blue when you turn the transceiver ON. Enter the password
(up to 4 digits) using the following procedure.
1 Set the Channel selector to position "1".
2 Press the Side 1 or Side 2 key to enter the fi rst digit.
• The Side 1 key increases the digit value and the Side 2
key decreases it. The transceiver announces the digit
number as it changes.
3 Repeat step 2 for Channel selector positions 2 ~ 4.
• If there are less than 4 password digits, repeat for only the
number of digits the password contains.
4 Press the PTT switch to confi rm the password.
• When the correct password is entered, the Blue LED turns off.
• If you enter an incorrect password, an error tone sounds
and the transceiver remains locked.
ADJUSTING THE VOLUME
Rotate the Power switch/ Volume control to adjust the volume.
Clockwise increases the volume and counterclockwise
decreases it.

BASIC OPERATIONS

11