Advertisement
FRONT OF THE JACK
Lifting Arm
BACK OF THE JACK
Rear Swivel Casters
POWER UNIT
ASSEMBLY
Assembly
Handle Assembly
• Refer to picture 1 when performing this step.
Align Quick Disconnect pushpin in upper
handle piece with attachment hole in lower
handle piece. Push upper piece into lower
piece until pushpin pops through hole.
• Carefully remove the rubber block (Picture
3) from the handle socket.
CAUTION: The socket will tend to spring
upward when the clip is removed. To prevent
possible injury, place one hand on top of
socket to control its upward motion when
removing clip with other hand.
• Sufficiently loosen the Handle Socket Screw
to insert the assembled handle (Picture 2).
Saddle
Front Wheels
Handle
Handle
Socket Screw
Pump Plunger
Oil Fill
Screw
PICTURE 1
Lower
Handle
Upper
Handle
Quick
Disconnect
• Line up the hex shaped hole located at the
bottom of the handle over the hex bolt inside
the Handle Socket.
• Lower the handle onto the bolt. Secure the
handle in place by tightening the Handle
Socket Screw.
NOTICE: ONLY use the handle provided
with this jack. Handle is specially designed
to properly fit into handle socket and engage
release valve.
FEATURES & OPERATION
Operation
Raising the Jack
• Place vehicle in park, with emergency brake
on and wheels securely chocked to ensure
lifting stability.
• Refer to the vehicle manufacturer owner's
manual to locate the approved vehicle lifting
points.
• Position the jack so that the saddle will firmly
contact the vehicle lifting point.
• Close the release valve by turning the
handle clockwise until it stops.
4
PICTURE 2
Bottom
of
handle
PICTURE 3
Rubber Block
Handle
Socket
Screw
Advertisement
