Fcc Notice; Warranty - GE 45633 Manual

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off or on, the user should:
• Relocate or reorient the TV or radio antenna
• Increase the separation between the device and the receiver.
Any changes or modifications to the equipment without JASCO's express consent will void the user's right
to operate this equipment.
FCC ID: xxxxxxxxxx
Compliance with IC Rules and Regulations
IC: xxxxxxxxxxxx
Jasco Products Company
Model: 45633 / ZW5303
Object is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation
of the device."

WARRANTY

JASCO Products warrants this product to be free from manufacturing defects for a period of two years
from the original date of consumer purchase. This warranty is limited to the repair or replacement of this
product only and does not extend to consequential or incidental damage to other products that may be
used with this product. This warranty is in lieu of all other warranties, expressed or implied. Some states
do not allow limitations on how long an implied warranty lasts or permit the exclusion or limitation of
incidental or consequential damage, so the above limitations may not apply to you. This warranty gives
you specific rights, and you may also have other rights which vary from state to state. Please contact
Customer Service at 800-654-8483 (option 4) between 7:30AM – 5:00PM CST or via our website
(www.jascoproducts.com) if the unit should prove defective within the warranty period,
JASCO Products Company
Building B
10 E Memorial Rd.
Oklahoma City, OK 73114
The GE logo is a trademark of the General Electric Company and is used under license to
Jasco Products Company LLC.
Made in China
© JASCO Products, 2010
Z-Wave is a registered US trademark of Sigma Designs
45633 Instructions rev 1-a.doc Page 14 of 14 1/13/2010